trans temp sensor

[fivefish]

Going to be adding a tranny temp gauge and have read some threads that discussed damage to the tranny from threading the sensor too deep. Can you all clear this up for me? How do I know when I've threaded to the appropriate depth?

 

[pafixitman]

Yep you can install it on the side of the tranny >>>> Click Here<<<<< The R4100 is the same as the E4OD some changes made inside but for the most part they are the same tranny. Just keep the temp below 200° F for long periods of time if using this location or in the pan mounting. It's o-k to go above it but not for very long (typically only while backing up a steep grade (say driveway or such) but let her idle till she cools down below 180° F before shutting off (the tranny will continue to "heat soak" for a little bit).


Courtesy of Goat Boy. Worked great for me.

 

[argve]

Most of the senders I have ever seen for measuring fluid don't have an adjustment for depth they just come with one depth fits all - so just slap it in the hole and tighten it down (snug - not cro-magna gorrilla tight - just snug - use tape but don't go overboard because too much will insulate the electrical connection).

 

[deanj]

If U have concerns, cut the out let tube and install a "T" . I think the tube is 5/16, so get 2 - 5/16 tube to compression fittings and cut 2" out of the tube.

 

[Agnem]

If you pull the pan down, you should be able to see anything that you would hit. You'll need to keep it low so it stays in the fluid.