Hey, Hopefully I found the right place to ask this question. I have a 1986 Isuzu NPR that I'm in the process of swapping a 14' wood platform flatbed onto. I purchased the flatbed used from some junk yard and had box steel cross beams welded between the two frame rails as the frame rails on the deck are wider then the frame rails on the truck.
The resulting cross beams look like this from the rear and there is 6 of them down the length of the frame. All properly welded by a professional.
There is a slight gap because the torque spring mounts for the leaf springs get in the way so I assume I'll need to use some sort of spacer material, originally I was going to use hard wood but I found a threads on this forum advising against wood, does anyone have a alternative or will wood be okay?
As for mounting I had intended to use square u-bolts diagonally across the cross beam through the bottom of the truck rails and around truck frame like so.
The catch is of the 6 cross beams only the 3 center cross beams have the room for me to fit u-bolts like this. All the other beams are either blocked by the torque spring mounts, fuel tank, or battery box. I've never mounted a flatdeck before so I'm not sure if 6 total ubolts only in the center of the deck is sufficient to hold the deck safely. I intend to be able to haul loads up to 4000lbs.
I could fab a few right angle brackets like this to add some sort of mount to the ends of the frame. (you can also see the offending spring mount causing the fitment issue in this photo)
any insight would be much appreciated. Thanks.
You must be registered for see images
The resulting cross beams look like this from the rear and there is 6 of them down the length of the frame. All properly welded by a professional.
You must be registered for see images
There is a slight gap because the torque spring mounts for the leaf springs get in the way so I assume I'll need to use some sort of spacer material, originally I was going to use hard wood but I found a threads on this forum advising against wood, does anyone have a alternative or will wood be okay?
As for mounting I had intended to use square u-bolts diagonally across the cross beam through the bottom of the truck rails and around truck frame like so.
You must be registered for see images
The catch is of the 6 cross beams only the 3 center cross beams have the room for me to fit u-bolts like this. All the other beams are either blocked by the torque spring mounts, fuel tank, or battery box. I've never mounted a flatdeck before so I'm not sure if 6 total ubolts only in the center of the deck is sufficient to hold the deck safely. I intend to be able to haul loads up to 4000lbs.
I could fab a few right angle brackets like this to add some sort of mount to the ends of the frame. (you can also see the offending spring mount causing the fitment issue in this photo)
You must be registered for see images
any insight would be much appreciated. Thanks.
Last edited: