1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Hello from Duncanville, TX

Discussion in 'Introduction' started by Jay Gallagher, Oct 20, 2020.

  1. Jay Gallagher

    Jay Gallagher Registered User

    Posts:
    2
    Likes Received:
    3
    Joined:
    Oct 20, 2020
    Location:
    Duncanville, TX
    I'm retired, sorta. upon retirement, I opened a small metal fabrication shop. I have a CNC PlasmaCam and just enjoy building stuff! I have a 1993 F 350, IDI 7.3, automatic, single rear tire, crew cab, 8' bed. It's similar to driving a school bus! Actually, it rides and drives easier and smoother than my 03 Dodge 3500, Cummins crew cab, 6 speed, flatbed. The Ford has been sitting for about four years. It got to where it wouldn't run and at the time, I didn't take the time to do much trouble shooting. It appeared the mechanical fuel pump was not supplying enough pressure. So, I'm attempting to get it back on the road.
    The adventure begins!
     
    Danielle and Thewespaul like this.
  2. Danielle

    Danielle OK, for real no more trucks now Supporting Member

    Posts:
    1,912
    Likes Received:
    722
    Joined:
    Jul 7, 2011
    Location:
    Dirty Jersey
    I'd delete that comment about a CNC if I were you heehee. You may regret sharing that bit of golden information!

    Just kidding and welcome!
     

Share This Page