Search results
-
10.25 Sterling Hub
I replaced the bearings and seal on my 1992 F350 Dually, This is my first time ever doing this job. I think everything went well till putting the hub back on. Was doing just what was asked. The hub went on just fine but stopped early I think leaving about 1/2 inch or less shinny gap...- IDIDually
- Thread
- #10.25sterling #dually #fordf350
- Replies: 0
- Forum: General, Performance, Upgrades & Accessories
-
2wd Front wheel bearings
Another first time attempting a repair and get stuck right in the beginning trying to order the dang parts. My front right (passenger side) wheel bearing (I assume) went out. It’s Making a metal twisting, grinding sound every time it hits a certain spot in the rotation. I parked the truck...- IDIDually
- Thread
- Replies: 6
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Rides like a 1971 Plymouth Fury lll
I‘m really in the need to replace all four of my shocks. Truck rides way to nice, squishy and squats a lot with an empty trailer. It’s a 2 wheel drive dually. It should ride like a dually truck. Well that’s my thinking. I’m looking for suggestions on inexpensive heavy duty shocks. I tow a 18‘...- IDIDually
- Thread
- #shocks
- Replies: 8
- Forum: 6.9L IH & 7.3L IDI Diesels
-
“Click” to “Click Click”
@Big Bart you were RIGHT!! Napa sold me a remain starter for I assume a different year. They were “almost“ identical. Pulled the starter back off, took it back to Napa. They pulled another starter from the back “the right starter“ Only differences were the opening where the gear comes out...- IDIDually
- Post #7
- Forum: 6.9L IH & 7.3L IDI Diesels
-
“Click” to “Click Click”
I replaced the, fender solenoid again, replace the ignition switch, replace the ignition cylinder today I’m going to look into the ignition lock and rod, then pull the starter off and have it checked, lastly inspect the new battery cables see if that helps. I have never heard of this ignition...- IDIDually
- Post #5
- Forum: 6.9L IH & 7.3L IDI Diesels
-
“Click” to “Click Click”
So I replaced my Starter, battery cables, fended solenoid Cleaned up all the ground connections. Put everything back the way I started (new). Truck fired up started awesome. Sounded Great. After a few mins of warming up at idle. (Truck sat for 2 months getting parts and cash to complete)...- IDIDually
- Thread
- #electrical 7.3 idi banks turbo idi starter
- Replies: 8
- Forum: 6.9L IH & 7.3L IDI Diesels
-
Possible battery cable diagram
Few days ago I pulled out all the battery cables and wires that go to and from the battery’s and passenger fender solenoid and to and from the starter.. Replaced the starter and fender solenoid And all the battery cables / terminals. Took a lot of pictures being this is the first time I’ve...- IDIDually
- Thread
- #7.3id #battery cables #electrical
- Replies: 1
- Forum: Introduction
-
So what did you do with your truck today?
truck Quit starting on me, I turned the key and you hear 1 click from the passenger side. Went and tapped on the started would turn over very slow. Turn the key off then try it again it was still slow but it was a little bit faster. Tried it again. Same. So I pulled my starter just to find a...- IDIDually
- Post #8,132
- Forum: 6.9L IH & 7.3L IDI Diesels
