Just picked up 1989 F Super Duty Dump
the Trans has a PTO On it and it has Gear oil in it..
I know it should have ATF.
just wondering how to or should I flush it some how??
Drove it for an hour or so,, actually seemed ok.
appreciate any advise.
Thanks
John
Thanks for all the replies.
Just bought the truck drove it a little over an hour to get it home and it overheated.
When I looked at the rad it looks like it might have a small leak or 2 in the core.
The biggest problem is the top talk looks like it split at the seam.
There isn’t a lot of rad...
I'm swapping the IDI out of my Rollback to a PSD.
I'm in Pittsburgh,Pa
Have completed motor, Radiator, ATS turbo Setup.
Motor ran pretty good, has a few leaks.
All must be picked up.
Email me if you are interested.
Thanks
John
Metrojd1@gmail dot com
The dash isn't all that bad.
Pull the collum and the emergency brake pedal.
The cluster and the kick panels.
There aren't as many bolts as you would think.
Un plug harness at kick panels including the grounds and The firewall.
Disconnect heater cables or vacuum lines.
I pulled my dash...
I did my CC
Need all under hood wiring and IDM , dash wiring,PCM and bracket throttle pedal.
When I did mine I put the power stroke and Radiator brackets in, overflow and washer bottle
I used a 96 wiring in my 93.
Had to change a few pins in the connector for the back lights.
Looks like a ps fluid and trans. Mix.....
I just topped it off with mercon.
Tried turning all the way right and all the way left to bleed out any air.
Drove it about 8 miles seems fine but wines like its low..
Any suggestions?
Thanks
John
Leaking inside the cab and once I park, it leaves a puddle under we're the driver side .
Looks like it's coming from around the small beer can looking thing area....
Brakes and steering all seem good though..
My hydra boost is leaking on my 450.
I have a new one coming Monday from ford.
My question is .......
Anything I should know about changing it?.??
Tips??
Do I need to bleed it in any way?.
Never delt with hydra boost before.
Thanks
John
I appreciate all the Input..
I just picked up this truck and it had this set up on it..
I need to figure out something..
its slobbering oil all over the Drivers Side.
I was thinking about brakecleaning it and using some of the Fort Gray Sealer....
Door Panels
I would be interested in the door panels..
Any more pic s??
I am in Pa about 3 and 1/2 from Columbus..
Would you sell the sending units out of the fuel tanks??
Please let me know.
Please EMail me.... I cant seem to check my Pms...
[email protected]
Thanks
John
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.