Hey all! I'm looking for a injection pump for my 93 f350 with the turbo 7.3. Don't have a lot of cash at the moment because I'm currently in college classes. Any one have one?
Thanks!
You are correct. This is a used pump I bought because the original went out . I still have it and was going to have it rebuilt but I was quoted 800 to have it rebuilt. So I scratched that.
On a side note I will sell it if any of you are interested in it. Aside from this problem that this...
What typically fails in the PSOM??? I've replaced the VSS and saw some punctured areas so I cut them out and replaced with new wire and then sleeved all of it. I pulled the rear cover to look at the tone ring and diddnt see any damage or slop or anything and still. Nothing. The speedo doesn't...
I also have the factory original turbo pump that I am going to rebuild (damn thing lasted almost 300k) so I can put it back in and a spare set of injectors that I want to rebuild as well.
Okay I'm with you now and so I apologize. I'm currently letting the engine cool down so I can remove the top housing and hopefully be able to get that broken off bolt out... I also have a carter epump that I'm going to try and install tomorrow as well. However fuel pressure was right about 6 psi...
Okay so update time. I moved the fuel pressure gauge and installed a new bleeder valve. Highest pressure I saw driving was 6-8 psi. It did the same loss of power and blah blah blah and so I shut the truck off and restarted it and never did it again... now I'm confused to hell and back...
I put some diesel extreme by hot shots secret in there right now. I like both hot shots and stanadynes additives so this time I figured I'd give hot shots a go
It's not leaking I was curious. Some people have said that what it's dripping is water out of the bottom piece that connects to the little tube that runs down the side of the engine down to the bottom of the truck. I don't have the wix filter I have the motorcraft setup. I'm thinking about going...
I don't have a schraeder valve in the filter head as it was replaced with the sending unit for a fuel pressure gauge. There is a new factory fuel filter installed currently. On that note is the filter bottom supposed to drip at all while running? I've heard yes and no but haven't been able to...
The throttle cable is brand new. I replaced it a couple weeks ago because the other one cracked.
The tank I was on was full.
I'll have to take a look and see about the lift pump
It happened suddenly. Everything was fine then all of a sudden no throttle response. I had pushed the throttle completely down and it may have reved up 500 rpms if that. Then it would die. I'd wait a minute and re-start and it'd idle fine, then I'd rev it one time and it would start idling rough...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.