Search results

  1. S

    1993 E4OD flex plate/ crank shaft spacer

    My Flex plate has broke. It galled the mating surface of the thick spacer between the end of the crank and the torque converter. I am looking for a replacement part. Can file on mine but would prefer using a better one.
  2. S

    93 IDI with E4OD.

    I am trying to finish the install of my Monster Tranny. I have more gripes about the tranny, but will vent later. I did not pay close enough attention to which electrical connector goes to the MLPS and which one goes to the solenoid pack. It is not obvious to me. One connector is grey and...
  3. S

    E4OD from Monster Transmission for my 1993

    Finally received my E4OD from Monster Transmissions after waiting nearly three months. I have the old tranny out and sitting beside the new one. I went to install the MLPS, but to my surprise, the length of the new shaft is about an inch shorter (the thickness of the MLPS) than the old one...
  4. S

    Where to find drive shaft parts?

    93, NA, E4OD, Regular Cab, long bed, 2wd, one piece drive shaft. The front driveshaft yoke wore out. In need of a replacement. Anybody have an extra serviceable one laying around? Thanks in advance.
  5. S

    E4OD troubles

    Having E4OD troubles in my 93 2wd, regular cab, long bed. Not able/willing to spend the necessary $ for the BTS solution. Looking for donor truck or parts collection to swap in a ZF5. Thanks in advance.
  6. S

    Will loose Torque converter bolts cause bad noises?

    Everything has been great with my '93 NA 2WD E4OD until the other night. Drove to work, no issues, cranked up to drive home, sounded like a can of nuts and bolts rattling around. I had to get home, so drove anyway. Noises stopped when underway, but came back each time I stopped at a light...
  7. S

    Seat Exchange

    I have a 93 RC. My seat is in need of repair/replacing. I have found a rear bench from a 2000 CC Super Duty for less than getting new foam and seat cover from LLC. Will a rear bench from a 2000 CC SD fit into my 93 RC? I've used the search function and found up to '97 will bolt in, but...
  8. S

    Need slip yoke for 1993 reg cab E4OD 7.3 NA

    The tail shaft housing bushing wore out (caused by bad/old/original U-joint, near 200K). Taking truck to trans shop to repair. The housing is fine and shop was able to replace bushing. The slip yoke is slightly messed up. I need another one. Shop said they could not find another to replace...
  9. S

    difference in MPG?

    I have a 93 NA with E4OD reg cab 250, getting near 20 mpg highway. I suspect it has a 353 ratio rear. Thinking of getting 94 crew cab dually turbo with E4OD. Do not know what ratio rear. Will there be a big difference in MPG between the two?
  10. S

    Thanks to OilBurniers members

    Another big thanks to all the posts and recommendations on this site. I was having starting issues when engine is hot and warmed up on my 93 IDI. The Old original starter has been telling me she was getting tired for a while, but I was not listening. Almost left me stranded. Used the great...
  11. S

    E4OD issues on 1993 F250 NA, RC, 2X4 with small trans cooler

    Readers digest version. 1993 F250 NA, RC, 2X4. My Dad used truck to pull heavy roller to compact dirt runway. Trans burns up, brothers installed rebuilt trans from who know where. Truck then sat out in the desert for near six years. I then inherit the truck. Trans acts weird on the way...
  12. S

    This Oil Burners forum is GREAT

    I want to thank all the people that post questions and all the people that post answers. I have had problems with my 93 from time to time. There has not been any that I could not find fixes here. If my truck has had it, so has somebody else's. Also, thank the moderators for not letting his...
  13. S

    Fiberglass Sleeper

    Does anyone have a sleeper for a regular cab 93 ford. Getting ready for a trip to Texas and taking my dog. The sleeper would give me some extra needed room. Would prefer not to have a cap, but it might come to that.
  14. S

    Free hydraulic oil

    I have four barrels of hydraulic oil that I need gone for free. Need picked up before Saturday. Oil Sitting in Odessa TX. (703) 624-4001
  15. S

    Hydraulic oil for free in Odessa tx

    I have four barrels of hydraulic fluid/oil that I need to get rid of before Saturday. Call me (703)624-4001.
  16. S

    Who knew brake fluid is conductive/what is the PN for the brake pressure?

    I have been chasing electrical Gremlims. Fuse 13 under-dash fuse block kept blowing. While under the truck, looking for frayed wires, I noticed what looked to be a brake pressure sensor was leaking/dripping and nasty looking. I disconnected and cleaned the plug, went back on top and put new...
  17. S

    Under-hood Fuse Box Diagram '93 IDI

    Now that my 93 IDI is running Great (thanks to Mel at Conestoga Diesel), I need to start finding my electrical gremlems. Does anyone have a pdf of the under-hood fuse block for a 93. Thanks in advance

Latest posts

Forum statistics

Threads
91,280
Posts
1,129,764
Members
24,098
Latest member
William88

Members online

Total: 624 (members: 1, guests: 623)

Share this page

Top