A friend of mine had bad luck with his K30. The lower radiator hose blew apart and he lost all his coolant and overheated the engine because he didn't notice it fast enough. As he wanted to pull to the side it already was too late and the motor started to die and stopped running.
He got towed...
After a long time I'm back with a weird problem with my oil gauge on my 88 7.3.
I know that it's just a 'idiot light' and not meant to be moving - but now it does !!! ...but in a 'bad' way:
If i accelerate the pressure drops so far that the engine light comes on. If I let off the throttle it...
I'm about to place a order at rockauto for some parts and my F350 needs a new brake booster badly. It's loosing vacuum pretty fast. I though if I'm into it so far I just order a new master cylinder too. My question is, at rockauto there are master cyl. with different bore sizes. Which one should...
This evening I was driving home from a little car show and just before I arrived at home my high beams started to go off and on rapidly.
As soon as I switched back to normal driving lights everything was okay.
If I switch back to high beams they work but after some time (seconds to half a...
UPDATE: Gearvendors OD no reverse
It's the third year now that my F350 has no real reverse and I want to fix that this year (for shure... :D )
It was not that bad because I helped me out with the good old D60 front axle to drive backwards if needed...
What happened:
Behind my C6 + BW...
Since I got my 96 F250 last year I noticed low voltage on idle but other than that no problems so far with electricity.
But now just out of curiosity I want to know from you guy if this is normal ;Sweet
(All measured with my Ford AIC module)
Idle 650rpm ~12.5V
At about 1100rpm ~14.5V...
Today just out of curiosity I floored the gas pedal for the first time since I own "this" truck (96 F250, bought it in arround april 2014) because i read about the 'skip' at arround 2200 rpm if you have bad injectors.
Throughout the rpm band it revved fine till 3000 rpm and then it revved up to...
I'm looking for new rear tires for my 96 F250 because the Yokohama Geolandar tires that I'm currently running (from the pre-owner) suck on light muddy terrain and even on gras. It just needs to be a bit wet and they start to spin "all day long" LOL
It doesn't help that the truck is only 2 WD...
One question:
The OBS Powerstrokes (in my case a 96, F250) have these lights near/arround the "wait to start" light (engine temp, fuel filter, ...)
I noticed after I bough the truck a couple month ago they don't light up like others I seen on youtube when i crank the engine. The only light...
I noticed today that my 96 PSD ist pushing the dipstick out of the tube after driving for a couple km / miles.
If I open the oil fill cap there is no excessive blow by just a little bit...
Any thoughts what could cause that?
I don't think my PCV is plugged but I'm not 100% sure on that...
I bought a 96 F250 PSD a couple weeks ago and the ZF5 in it makes noise in 3rd gear.
It sounds a bit like if it would be in reverse.
The truck has 222200 miles on it.
I don't know when the fluid was changed last time and normally I change all my fluids if I buy a "new" car/truck but I want...
As some of you may know I bought a 96 F250 2WD last week with the ZF5 in it.
(222000 miles)
When I start it up it starts fine but rattles a bit, if I press the clutch in when I slow down it shakes/rattles a bit too and if I shut it down it quits with this typical "clunk".
So I think I need...
Does anybody know if a 1987 E250 windshield and chrome frame fits a 1988 F350 ?
I'm asking because I'm missing half of my chrome frame and I want to cut out my windshield to repair rust (and if it brakes I would have a spare).
Thanks
Chris
Now since it's april I can drive my truck again (it's only registered/insured from april till october and not through the winter) and discovered a little problem:
If I drive slowly over bumps or something that makes the truck twist a little bit, like a driveway that goes up or downhill, there...
I'm getting a new to me 96 7.3 Powerstroke F250 2WD long box 5-speed manual transmission next month with ~220000 Miles. Seems to be completely stock, runs good, no tuner, factory exhaust, no air intake mods or something like that.
Til 2011 the truck was registered somewhere in Kansas and is...
Can someone help me?
(Dana 60 front axle)
I bought this Kit from rockauto couple days ago and I'm not really shure in wich order the parts go in the axle.
It's this kit http://www.rockauto.com/catalog/moreinfo.php?pk=227407
There is the bearing, the bearing race, the lower seal (with...
I'm sorry I know this topic is asked over and over again but it looks like I can't get Rotella (what seems to be the most used / best) here in germany.
I have to change my oil this month and maybe you can tell me whats the best to use (in my 7.3 idi).
I can get these oils for example...
For all the non believers ... :D
Last year I installed a coolant filtration system on my 7.3 and drove it for only 500km (then the registration season ended - the truck is only registered and insured from april till october - it's a summer driven truck ;Sweet ) - Now I decided to take a look...
Hello.
Can anyone tell me for what those connectors on my 88 F350 7.3 are? I'm searching and searching and can't find anything.
They are on the driver side under the master brake cylinder ... as you can see on the attached photos.
Thank you in advance.
Greetings from germany
Chris
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.