Search results

  1. Kdo58

    Where do these brackets go to?

    They say rh and lh
  2. Kdo58

    Strange glow plug/accelerator issue

    Disconnect the high idle plug see if it happens again, or follow the throttle cable to see if a wire is rubbing it.
  3. Kdo58

    IDI return line caps - aluminum 6061!

    He sold 2 sets on ebay.
  4. Kdo58

    Truck wont start when cold

    Glow plugs or controller,
  5. Kdo58

    Delphi Return Line Kit From NAPA

    I use the 7.3 on my 6.9 I just cap off the dead end cap.
  6. Kdo58

    Pyrometer placement

    Cdd recommends it in the cross over pipe, I put mine in the exhaust manifold, like the others
  7. Kdo58

    Facet 40290 pressure issues

    You might try clasic diesel designs on fb, they chime in all the time and will give you the right info.
  8. Kdo58

    Facet 40290 pressure issues

    Facets don't have enough volume for a turbo motor, not saying that's your problem.
  9. Kdo58

    Locking the advance piston on a db2 rotoary pump

    https://www.oilburners.net/threads/db2-tuning-guide.83813/
  10. Kdo58

    rotary fuel pump

    I had it for two years, when I first started out on the idi journey I installed a faccet fuel pump, then I found out it does not have enough volume. I use it for a pre filter for the holley, but added a switch to it for a back up, incase the holley quits.
  11. Kdo58

    rotary fuel pump

    Holley red, but I have a turbo
  12. Kdo58

    Injection Pumps

    https://classicdieseldesigns.com/collections/turbos-and-turbo-parts/products/cdd-idi-turbo-rebuild-and-upgrades 5 yr warranty
  13. Kdo58

    Before I buy injection pump....

    Cdd has a fb page which they are quite active on.
  14. Kdo58

    Before I buy injection pump....

    When ip was bad I would turn it over with a line disconnected at the injector and it would just dribble out.
  15. Kdo58

    stereo installation

    And carpet with mass backing
  16. Kdo58

    "Prime" the fuel system before starting?

    5-8 seconds is not long enough, when iwent to a push button glow plugs, I took a glow plug out and hooked it up to 12 volts and I counted to 14 before it got glowing red. I also have a electric fuel pump.
  17. Kdo58

    Figuring out best place to wire these gages

    Sounds like you have glowshift gauge, I ran all my power from the fuse panel, my 87 had unused ports in the fuse panel.
  18. Kdo58

    1992 f250 with 7.3 idi long crank, start but dies, 8 hours after sitting,fuel filter at 1/4

    YouTube has lots of videos
  19. Kdo58

    7.3 idi problem

  20. Kdo58

    Had my side window shot out. Some tips on installs.

    Does it have a wing vent?
  21. Kdo58

    6.9 idi lacks low end torque/power

    The main difference between the motors is the 7.3 has a larger ip pump.
  22. Kdo58

    99% sure it's the booster. Thoughts?

    I replace booster and master cylinder at the same, usually the master cylinder leaks into the booster and ruins it.
  23. Kdo58

    ATS Turbo Oil Feed Leak

    https://classicdieseldesigns.com/products/turbo-oil-feed-line-kit
  24. Kdo58

    turbo replacement - clearance issues

    I would post this on cdd facebook group, cdd will usually chime in.
  25. Kdo58

    7.3 knock

    I would pull the valve covers off and see if anything is loose.

Latest posts

Forum statistics

Threads
92,996
Posts
1,155,942
Members
26,575
Latest member
Gerhard

Members online

Total: 1,602 (members: 4, guests: 1,598)

Share this page

Top