Search results

  1. C_Luft

    Ip timming/gauge compression

    Your engine is fine, every once in a while a seal will go out, no need to replace the engine just because one seal started leaking. Now this is my old engine, it was really worn out it leaked/burned 2 gallons of oil in 250 miles, it has 2-3 cylinders worn out. https://youtu.be/VAggOk5ID_A
  2. C_Luft

    Junkyard wishlist anyone??

    Have you seen any late model obs crew cabs, I've been searching for a full power window harness for a while with no luck. at my local yards.
  3. C_Luft

    bumper replacement

    I was rear ended back in September and my bumper was damaged, so after a couple months of looking for a bumper I found a fey deep drop bumper with built in lights that I liked and haven't had time to install it, I was wondering do most bumpers use the same brackets or do I need to track down a...
  4. C_Luft

    never seen anything like this for sale

    My grandma has one with 12000 miles http://www.fourdoorbronco.com/board/showthread.php?7634-Grandpa-s-94-magnum-cummins
  5. C_Luft

    Somebody scored bigtime

    I just received a j33300 that i bought on ebay for $40. Green screen, came with magnetic probe, injection line clamp and harness and timing light although I don't think the light works. Is the the lumosity probe needed, does it work better than clamp method?
  6. C_Luft

    Oil Filter housing threads damaged. NEED HELP ASAP!

    I had the same issue with my truck, I ended up putting on a K&N oil filter and using the nut on the end of the filter to snug it up to the housing. That was after going to two different orielly locations for a Motorcraft powerstroke oil filter to see if I simply got a bad filter. It seems that...
  7. C_Luft

    Another glow plug circuit issue

    As the title says I have an issue with my glow plug circuit, my glow plugs are new(motorcraft) as of Sunday. I an still getting a lot of clicking after 2-3 seconds of wts light (and hard start at 45°). My harness is in (visually) good shape I only needed to re do one bullet connector on Sunday...
  8. C_Luft

    Powerstroke turbo or factory

    You can get more than 7 psi without adding more fuel, I'm running stock fuel (no adjustments on the injection pump). When I added my tripod (pyro,boost,transmission gauges) I simply unhooked the waste gate because I didn't have enough hose to put a proper T in. I have seen as high as 11psi with...
  9. C_Luft

    Performance parts

    I have a set of 2200 psi injectors from that site, my truck burns clean all the way up to 11psi(max) unloaded. Although I don't think he sells the 2200 psi injectors any more due to making the injection pumps hot. (That's what I heard).
  10. C_Luft

    Rough ride

    I haven't checked my tire pressure in a while, but I'm taking it to Les Schwabs tomorrow to have them check every thing. I'm pretty sure my leafspring bushings are bad and I know my radiator support bushings are cracked. I always keep my hubs unlocked. How often do you need to replace the...
  11. C_Luft

    Rough ride

    I haven't pulled the tires off all since I've owned it, the tires are 32's or 33's I think, I could probably have then balanced this weekend. Any other things to consider?
  12. C_Luft

    Rough ride

    After changing my rear u joints and shocks all around I'm still getting a rough ride at 60-70 mph, kinda feels like I'm driving on a washboard road if a hit a certain spot on the hwy that has a few bumps in the road. Any suggestions
  13. C_Luft

    Transmission/differential fluid?

    Please put your truck info in your signature, you can look at your driver side door jam or on the door itself it will give you the Vin code and maybe the axle code
  14. C_Luft

    Quick WTS light flash

    I kind of have the same thing here also, but my wts light will go out after 8-10 seconds, and my voltmeter won't go back to up until about 5 seconds after the wts light goes out. My truck will start up after about 1 or 2 revolutions after waiting for the wts and voltmeter, just curious if this...
  15. C_Luft

    timing???

    If you wanted to rent a meter it's 70 from icanfixall.
  16. C_Luft

    motor mount replacement?

    When I did my oil cooler I didn't have to pull the front drive shaft or lift the engine, I pulled off the drivers front wheel, the power steering/vacuum pump bracket and unhook your steering shaft from the steering box and I had enough room for the oil cooler to come out.
  17. C_Luft

    timing???

    I live in battle ground, WA, I don't have a timing meter, but when I had to get registration for my 94, for a few reasons(bad engine is one of them) I had to put my dad's address who lives out of town where deq is not required. Pretty much anywhere on WA side out of Vancouver they don't require...
  18. C_Luft

    [HELP] Truck won't start

    I would pull the glow plugs and try to see if the engine will turn over in case of water in the cylinders, then if it still isn't turning over, I would pull the starter, take it to your nearest autoparts store and have it tested, then pick up some new battery cables, those are probably a big...
  19. C_Luft

    F350 crew cab 6.9 idi

    3000 for a brand new unit, 500-1500 on ebay/craigslist.
  20. C_Luft

    F350 crew cab 6.9 idi

    Or you could add a gear vendors over drive and only really need to shorten your drive shaft, that way you have a bullet proof drive train, with no electronic crap to go wrong.
  21. C_Luft

    94 f250 could not start

    I would only recommend Conestoga diesel injection, you pay for what you get for. Mel is a really stand up guy, never met him or bought any products from him but he would be my first choice to get a quality rebuild.
  22. C_Luft

    94 f250 could not start

    I suspect the injection pump is on its way out. I have the same problem, after driving the truck has been warmed up and then you turn it off and let it sit for more than 30min to an hour the injection pump will get heat soaked and it will not start until the engine is completely cooled down or...
  23. C_Luft

    BILLET ALUMINUM INJECTOR CAP PART 2

    I used to work for Sapa anodizing in Portland and they can make pretty much anything aluminum, if I have time tomorrow I will swing by there to see what the cost would be for a set of 8 injector caps.
  24. C_Luft

    Who can tell me why these leak?

    You may want to check your Transmission fluid level is too high, when I was trying to figure out what was wrong with my e4od, I added like an 1/8th of a quart too much and it would drip from there for a couple days and then it went away.
  25. C_Luft

    help with getting my truck to run at the right temp please???

    I don't know why ford would put these idiot gauges in trucks that need real gauges, it's really a hit or miss if they look correct, my current truck doesn't get over N on my gauge, but I can see when my thermostat opens and I know my truck runs at operating temp. You may get away with pulling...

Latest posts

Forum statistics

Threads
92,932
Posts
1,155,156
Members
26,432
Latest member
pwillis

Members online

Total: 859 (members: 4, guests: 855)

Share this page

Top