Search results

  1. ADV

    Very possibly the coolest van you will ever see....

    one question comes to mind WHY??????????
  2. ADV

    runing WMO in a 7.3idi

    thats what mine runs on.
  3. ADV

    Rad line broke

    Did you make it home? How many miles on the engine? If you have bubbles in the coolant that sounds like it could be something internal. You might want to post this in the 6.9 7.3 IDI section you will get a few answers there.
  4. ADV

    tekonsha commander xp brake controller

    when you hooked up the red wire to the brake pedal switch did you tap in to the right side? one side oe the switch has 12v constint power.
  5. ADV

    F-super duty front springs on a 4x4 F350?????

    I was thinking about putting fsuperduty springs in my truck but with the extra height it would not fit in the garage to work on it anymore.
  6. ADV

    Hydro boost??

    I pulled the hydrobost and master cylinder out of a 1988 fsuperduty and put it in my 93 f350. I used the power steering pump form my 93 and just swapped the tank that was easier than swapping the pulley.
  7. ADV

    Speaking of Frankenstein's seats.....

    I am going to work on it next Saturday I hope they are marked I will pull my bench out and lift up the rubber floor and take a look. They are very nice siting seats and I would have a place for my coffee cup a bonus.
  8. ADV

    Speaking of Frankenstein's seats.....

    I just picked up a 40-20-40 bench seat out of a F150 it is in really nice shape. I was hoping they would bolt in with at least with the out side 4 bolts well that's not the case i will have to drill all 8 holes to make them work.
  9. ADV

    How hard is it to put in a new rew window?

    I have replaced a few rear windows. If you have the 2 part gasket its easy.
  10. ADV

    1988 f250 parts

    i am sure my wife would like it if i put some p235/75r15s on my truck it would be easier for her to get in. But its more fun to watch her jump in.
  11. ADV

    Brake Master Cylinder

    The fsuperduty master cylinder on my truck says 1 5/16 on it.
  12. ADV

    1988 f250 parts

    dad only might need the clutch. i will put the pedals on your not so small pile of parts in my garage. you are going to buy me that set of tires yet.
  13. ADV

    1988 f250 parts

    drive shaft yes. clutch and flywheel i need to check on i think my dad was going to need it for his fsuperduty unless he sells it. i am going to have a big load going north to your place.
  14. ADV

    1988 f250 parts

    the a piler trim is yours for the cost of shipping. the truck i am parting out is a extended cab i would have to see what would work in a single cab.
  15. ADV

    1988 f250 parts

    i have the trim but the headliner was bent down in the front i dont know how good it is. is this for the truck you have pictured?
  16. ADV

    1988 f250 parts

    how much of the trim do you need? door pannals are gone.
  17. ADV

    1988 F250 extended cab rear jump seats fold agains the sides.

    these are in the 88 f250 I am parting out I have never seen them in any other extended cab. They are in nice shape. $100 or make offer
  18. ADV

    1988 f250 parts

    carpet some holes some stains, extended cab, I have the pillar trim, the trim above the windshield is gone. Blue carpet blue trim
  19. ADV

    1988 f250 parts

    Sorry I have no bell housings
  20. ADV

    1988 f250 parts

    I am not exactly sure what the green thing is my Dad and i do a bit of scrapping and that's something he brought home and threw on the trailer.
  21. ADV

    1988 f250 parts

    here is a picture of the bumper with grill guard, i have a dome light with the 2 map lights from a extended cab. I should have the under hood insulation and hood light but I need to check the condition. I do not have any receiver hitches or any under the dash lights.
  22. ADV

    1988 f250 parts

    I have the axle I thinks it has 3.55 gears. I was thinking about keeping the spindles and the hubs I think they are the same as a dana 60.
  23. ADV

    1988 f250 parts

    the truck is in the Sheboygan area
  24. ADV

    1988 f250 parts

    I will pull the wires and everything.I will try to get as much wire as i can. When I get it out I will let you know it will take me a few day to get at that.
  25. ADV

    1988 f250 parts

    I have the tank. let me check to make sure its not cracked or broken. If its good its yours for the price of shipping.

Latest posts

Forum statistics

Threads
92,932
Posts
1,155,156
Members
26,432
Latest member
pwillis

Members online

Total: 898 (members: 5, guests: 893)

Share this page

Top