Search results
-
V
IDI return line caps - aluminum 6061!
I like the idea of clamping without “clamps” Went back and seen a recent post I think his picture, and post described what I was thinking about as well. Clamping without clamps… :)- VanGo
- Post #37
- Forum: 6.9L IH & 7.3L IDI Diesels
-
V
E350 7.3 idi engine replacement
Was able to work on for a bit. Almost ready to move in building to pull engine. Hopefully I can get to it soon. Looked over the IP on the bus engine, both engines have manual Linkage on the IP, it may be possible to use. I just order a new water pump since I am unaware of the condition on...- VanGo
- Post #9
- Forum: 6.9L IH & 7.3L IDI Diesels
-
V
E350 7.3 idi engine replacement
Yes that’s what I suspect. Since I may not be able to use the critical parts from the new doner engine, I may end up just getting another IP and a couple other items. The engine only has 53,000 miles and I am not sure I want to chance it by using items off the old engine that I have no idea of...- VanGo
- Post #7
- Forum: 6.9L IH & 7.3L IDI Diesels
-
V
E350 7.3 idi engine replacement
Thanks , it is an international engine…. I take it the linkage from the old Ip can not be used? Is there an easy way to bench test an IP? I have no clue what type of condition the old one is in. They also had an extra one sitting in the van . They may have tinkered with them. But it does...- VanGo
- Post #4
- Forum: 6.9L IH & 7.3L IDI Diesels
-
V
E350 7.3 idi engine replacement
Hoping to ask a few questions along the way. I purchased a 1992 E350 extended van. The 7.3 idi engine is to be replaced. I purchased a doner engine that was pulled from a school bus with 53,000 miles. Prior to purchase while the engine was still in, we had the engine cold started ( although...- VanGo
- Thread
- Replies: 8
- Forum: 6.9L IH & 7.3L IDI Diesels
-
V
New to forum
New to forum, new to diesels, new to 7.3 idi, heck never even owned a van before. Joined to ask questions along the way in swapping a 7.3 idi in a 1992 E350. Will start a separate thread. Thanks, Ed- VanGo
- Thread
- Replies: 2
- Forum: Introduction
