But I still could get fancy and use my programmable time delay circuit board to power the pump For 20-30 seconds with a trigger signal from the...
Well the way mine is setup is the fuel pump will run when the truck is cRanking as well as when once it gets above 2psi of low pressure oil. I...
I used the oil pressure switch for the same reason you used the inertia switch. I wanted to make sure that pump wouldn't be pumping in the event...
I have a electronic programmable tune delay board I'm going to wire in. But jumper it first to see if that's the issue.
I put did a custom e fuel setup, new ball joints, wheel bearings, tie rods, from axle u joints, new dash pad and got new wheels and tires. She is...
Ok. Changed the glow plugs with motorcraft. Also swapped out the engine harness as I found two burnt plugs for the uvch. The truck starts and runs...
I will thanks.
I apologize for not being able to keep it all together. I have had multiple problems and have had to fix them one my one. My glow plug relay is...
Ok so e fuel is installed and the truck starts much better but still has a 3-4 second crank time and a bit of white fuelly smoke. Any ideas?
Ok update: I used a bore brush for a gun to hold the oil dipstick adapter. Worked perfectly. Through a lot of praying I finally got the freeze...
What's the best method of holding the dip stick tube adapter? I've heard a gun bore brush? Coat hanger? What would you recommend
Anyone?
Update, I hand turned the engine over and I heard the freeze plug clearly hit the bottom of the pan. Thoughts on leaving it there or trying to...
Please help. I think I just completely screwed my engine but I need yall to tell me yes or no. I was installing the freezplug in the top of the...
Holy crap! I think I just had an epiphany! This started to get worse when I pulled th front tank to swap the sensing unit out and the selector...
Honestly the mechanical pump is fairly new. As in a few months old. But if that's the issue I'm going to Do the e fuel this weekend. I hope that...
It takes til it starts to get up to pressure. So I was wondering if I had a fuel flow prob which is why I have amassed the parts to do e fuel this...
Hpo Res is full. I tried a pcm from an auto truck and my truck did not like that. Not at all. But it did not start any quicker anyway. I have a...
The last one is from a really strong truck that starts as it should
Ok, removed chip. No change. Unplugged icp, no change, swapped out cps, no change. Here is a screenshot of the icp and ipr during a starting...
Honestly I forgot. I will do that when I get back to the truck and report back. Ive had a time working on these problems as my wife has completely...
This may sound crazy but what about adding a low pressure fuel pump after the selector valve to make sure I have fuel to the bowl? I am at a loss...
The only weird part is this has happened on two different engines. I just swapped in a 225k engine and it started up well for the first couple...
Ok, so I found a fuel leak in the valley Changed all hoses clamps and seals in the filter housing. This did not fix the issue. I changed the fuel...
Ok. I will do that. They are supposed to do that on their own as they only go in one way I think but I'll look. Thanks for the reply.
Separate names with a comma.
