Macrobb
Full Access Member
I just ran into an IP I have which has input shaft end play.
The end moves in and out about 1/8" or so.
The weird thing is... It still works fine! However, due to that shaft play, the gear can move in and out by 1/8", which actually changes the timing by a couple of degrees... so I'm going to have to fix it.
Any ideas on what might cause this?
The end moves in and out about 1/8" or so.
The weird thing is... It still works fine! However, due to that shaft play, the gear can move in and out by 1/8", which actually changes the timing by a couple of degrees... so I'm going to have to fix it.
Any ideas on what might cause this?