6.9 -- 7.3 IDI Freeze plug install tool.

Status
Not open for further replies.

Jritchie

Registered User
Joined
May 24, 2018
Posts
8
Reaction score
0
Location
Tucson
If you cannot find a freezeplug tool, you could always have a good machinist make one for you. I'm sure it would be borderline expensive, but it would be the right tool for the job. Also, it would be a lot less expensive than a new engine.

Some one long ago published a design drawing. I just tried to upload it, but apparently the image is too large, at 1.72 Mb. I'd be happy to sent it to you as an email attachment.
I would like this information also.
 
Status
Not open for further replies.
Top