Tristan
Full Access Member
Are front driveshafts all the same or different between manual and automatic trucks?
Front Driveline Length
- Thread starter Tristan
- Start date
Rdnck84_03
Full Access Member
If I remember correctly I think the zf5 requires a shorter front and longer rear than the e4od.
James
James
I don't think that's accurate, my crew cab was originally a E4od and when I zf swapped it, i used the original shaft.
Only major difference I know of is 250s use a single u joint end, and 350s use a double cardon joint.
Only major difference I know of is 250s use a single u joint end, and 350s use a double cardon joint.
Fwiw
Cuz it bolts on, doesn't mean that it fits.
Unless both tyrannies measure the same length.....
No
Full stuff you want 1" of collapse left.
At full droop you want AT LEAST 2" of engagement.
Cuz it bolts on, doesn't mean that it fits.
Unless both tyrannies measure the same length.....
No
Full stuff you want 1" of collapse left.
At full droop you want AT LEAST 2" of engagement.
Rdnck84_03
Full Access Member
I was thinking the zf5 was significantly shorter. My e4od to zf swap was in a 94 460 truck but the general setup is the same. Zf6 and 4r100 are the same length, pretty sure the overall length of 4r100 and e4od are the same
Austin86250
Full Access Member
I
every 250 idi ive seen had the double joint
Every 250 idi I've seen had a single.
hacked89
Full Access Member
Every 250 idi I’ve seen had single as well
Similar threads
