HELP Pin relocation for hydroboost HELP

Colin Mccormick · Mar 5, 2021

I was wondering how much higher i have to relocate the break pedal pin to work with a hydroboost setup. I have a 9/16 bolt with lots of shoulder. I do see on some posts that 3/4 is the height but i thought i seen like 1in to 1 1/4 higher to center like 8 months ago but most threads say 3/4

gnathv · Mar 5, 2021

Have you tried it without moving the pin? On my first truck I moved the pin. On my second truck I did nothing. The pedal is slightly higher, but after driving it that way it now feels natural.

you could also install your hydro boost and mark where the eye hits on your pedal arm and go from there.

u2slow · Mar 5, 2021

gnathv said:
you could also install your hydro boost and mark where the eye hits on your pedal arm and go from there.

That's how I did it to come up with 3/4".

In the stock position I felt it was binding.

hacked89 · Mar 5, 2021

3/4"

https://r.tapatalk.com/shareLink/to...&share_fid=72600&share_type=t&link_source=app

Sent from my SM-G955U using Tapatalk

Colin Mccormick · Mar 5, 2021

Did you just go from 3/4 from center of old pin or the top of pin 3/4 up

hacked89 · Mar 5, 2021

Colin Mccormick said:
Did you just go from 3/4 from center of old pin or the top of pin 3/4 up

From the link:

"Step 5:
Set up in your vice and drill a pilot hole 3/4" up the pedal from the center of the original pin hole. If that isn't clear the center of your old hole and new hole are 3/4" apart. "

Sent from my SM-G955U using Tapatalk

TahoeTom · Mar 6, 2021

I drilled and tapped the hole and chamfered the back side. After threading in the bolt I cut the excess threads off and welded a bead in the chamfer.

HELP Pin relocation for hydroboost HELP

Colin Mccormick

Registered User

gnathv

Full Access Member

u2slow

bilge rat

hacked89

Full Access Member

Colin Mccormick

Registered User

hacked89

Full Access Member

TahoeTom

Supporting Member

Similar threads

Latest posts

Forum statistics

Members online

Share this page