ih8minimumwage
Latest activity Postings About
-
-
I had had a 3cyl Geo Metro that overheated ******* the highway (radiator leak i didn't catch). I had just enough coolant with me and... -
ih8minimumwage replied to the thread Inj. pump line tool?.Or you can get all fancy with a Snap-on FRX201 injector nut socket
-
-
ih8minimumwage reacted to Old Goat's post in the thread Still possible to get a 6.9/7.3 4x4 for under $10k? with
Like.
This just came up today. 93 F-250 4 X 4 $5K https://sfbay.craigslist.org/scz/cto/d/scotts-valley-1993-f250-diesel-4wd/7481429387.html Goat -
ih8minimumwage reacted to IDIBRONCO's post in the thread Still possible to get a 6.9/7.3 4x4 for under $10k? with Like.
With a bad engine, that seems pretty steep to me. Spare engine aside.
-
ih8minimumwage replied to the thread Lines at Inj. Pump question.1" for the hex on the injectors. Might try to tighten it down and see if it seats again, may have just come a little loose when...
-
ih8minimumwage reacted to Nero's post in the thread Still possible to get a 6.9/7.3 4x4 for under $10k? with Like.
What in the fart did I just read :joker::joker:
-
ih8minimumwage reacted to Jesus Freak's post in the thread Still possible to get a 6.9/7.3 4x4 for under $10k? with Like.
The thing is, that Cummins COMMANDS a higher price over the IDI trucks. And quite frankly, I'll always say it's almost a "worship"...
-
ih8minimumwage reacted to u2slow's post in the thread Still possible to get a 6.9/7.3 4x4 for under $10k? with Like.
Give it another year or two. Lots of wishful-thinking and 'feeler' grade ads still due to pandemic fallout. You want to see overpriced...
-
ih8minimumwage reacted to ISPKI's post in the thread So what did you do with your truck today? with Like.
Running a big trailer harness cable in the "new" truck. I want to path it under the trim piece on the drivers side, up under the dash...
-
ih8minimumwage replied to the thread Zf clutch fork pivot ball.Worst case, find a local welding shop that can build it up and sand it back to round.
-
ih8minimumwage reacted to IDIBRONCO's post in the thread Does anyone have a spare valley pan for sale? with Like.
It's easier than trying to cut new gaskets.
-
ih8minimumwage replied to the thread Does anyone have a spare valley pan for sale?.Well ****, I'll just go that route then.
-
ih8minimumwage reacted to IDIBRONCO's post in the thread Does anyone have a spare valley pan for sale? with Like.
You can, but I clean off all of the factory gasket material and use a thin coat of RTV on each side of the intake gasket.
-
Thanks to my wife for the Christmas gift. I finally put them on.
-
ih8minimumwage replied to the thread Does anyone have a spare valley pan for sale?.Well, shows how many years it's been since I dug into my engine. Gasket material was well cooked onto the heads and all tore from the...
-
-
Loading…
-
Loading…
