Recent content by Coopons

  1. Coopons

    Ford Factory E-Locker Teardown (and some discussion)

    Excellent write up! I like they way you took it apart and showed the internals. I'm running one in my 96 stroke that I rear axle swapped with an 09 10.5. But I never actually took mine apart to see how it worked. I also just have mine wired to a relay and switch. Side note I payed $400 for a...
  2. Coopons

    using xylene

    thank you for the info.
  3. Coopons

    using xylene

    I'm running my first batch made with xylene now. Only have about 50 kms on the truck since I filled up the back tank this morning. Used about 10 litres to 205 litre drum of wmo. Not to sure on that ratio just yet as it did have about 20 litres of old diesel in it as well from a tractor I was...
  4. Coopons

    using xylene

    Well I'll give it a try on my next batch see how it goes.
  5. Coopons

    using xylene

    Hey guys has anyone used xylene for thinning their wmo instead of rug? I can get my hands on a very large amount for free. Its a pretty heavy duty solvent, so i'm wondering how it might affect overall engine components.
  6. Coopons

    Walbro electric pumps?

    just looked at these, not sure if they are going to have the PSI required. A stock super duty 7.3 pump runs at around 40PSI. I think this is what I'm going to try next
  7. Coopons

    Walbro electric pumps?

    I have the Irate diesel electric fuel set up on my 96 stroke. It uses the Walbro GSL392 pump, in the 2.5 years I've had it I've gone through 4 pumps. Some were running straight diesel and some on wmo. I'm in the process of trying to find something better. I'll check out the ones mentioned above.
  8. Coopons

    fuel gauge always reads full

    awesome thanks for the quick reply I'll check it out tomorrow and give an update
  9. Coopons

    fuel gauge always reads full

    Ok guys and gals, I have a 1996 F350 ccsb with a 7.3. Rear fuel tank always reads way pass full does move until I switch tanks then it reads as it should Tried a spare sending no dice. I verified that it worked by checking it before I pulled from donor truck Any one have a wiring diagram for the...
  10. Coopons

    Diesel craft centrifuges in mobile setup

    Could you not run your second centrifuge off the bypass line and use another valve to achieve the correct pressure?
  11. Coopons

    Filtered wmo in carbureted oil stove?

    Way to go guys! Now you have the wheels turning in my noggin, this sounds like a great way to heat my back woods shop.
  12. Coopons

    Advice on 1995

    Sounds like a half decent deal. I payed $3000 for my original F250 4x4. The average going price around here is $6-8000. I got a family deal on mine.
  13. Coopons

    Is this 200k miles PSD a good buy?

    Looks like typical sort of rust for the year. Nothing that I would worry about. Probably going to need a new exhaust from the look of it.
  14. Coopons

    Is this 200k miles PSD a good buy?

    On another note I don't know how to check for this but it seems a lot of trucks of this year the speedo rolls back at 400,000 kms. Back to 300,000. It happened in my truck and to at least 2 other guys I know personally. Not sure if any of you Yankees have had that happen to you.
  15. Coopons

    Is this 200k miles PSD a good buy?

    First thing is the price is way to high. In Canada a fully loaded cclb psd cost a little over $35g brand new in 1996. That's in Canadian dollars. If you are serious about a psd here are the things you need to look at and know about them As Greenkeeper was saying, oil pan make sure it's not...
See more

Latest posts

Forum statistics

Threads
91,262
Posts
1,129,487
Members
24,091
Latest member
freqencyheight

Members online

Total: 582 (members: 4, guests: 578)

Share this page

Top