Recent content by Clemens Kruse

  1. C

    Which Rear Axle Ratio? (31ft MH, 7.3idi turbo, Allison 1000)

    I will start another thread to ask for recommendations to rebuilt the engine. Yes I’m planning to do new head studs, new pistons etc. and it will be outside. The engine is free...
  2. C

    Which Rear Axle Ratio? (31ft MH, 7.3idi turbo, Allison 1000)

    Hey Nick! Nice to meet you here. I actually planned most of my setup based on yours. :-). I planned for the exhaust 3.5”. Should I go bigger to keep the egt low?
  3. C

    Which Rear Axle Ratio? (31ft MH, 7.3idi turbo, Allison 1000)

    The problem is that I got the hyper max new. It’s not even installed.
  4. C

    Which Rear Axle Ratio? (31ft MH, 7.3idi turbo, Allison 1000)

    Even with a wicked wheel 2?
  5. C

    Which Rear Axle Ratio? (31ft MH, 7.3idi turbo, Allison 1000)

    Hello, I'm slowly coming along with my project, but in the near future I have to decide which rear axle ratio will be installed. My Setup: 31ft Airstream 310 Motorhome Max. 14500lb., Dana 70HD Axle, 7.3idi with Hypermaxx turbo. (Rebuilt is planned, I will consult the forum, right now the plan...
  6. C

    In case of EMP

    This is an interesting thread. But I can calm you down. I might not know much about Diesel engines, or 7.3idis. (Be prepared- I’m planning on rebuilding a 7.3idi with turbo and will have a lot of stupid questions) But I’m working in aerospace and did a lot of electrical testing. (Mostly EMI) And...
  7. C

    7.3IDI - how much fuel flow on supply line and return?

    Hello, I want to create a mpg meter for the 7.3IDI. Two flow meter and I subtract the return line from the supply line with a micro controller. This is no problem, but I need to choose the right flow meters. Does anyone know how much fuel goes min/max through both lines? (the supply line can...
  8. C

    7.3IDI, move heater supply outlet to driver side

    Hello, the heater supply for the cabin heater comes out of a stud on the passenger side. On both sides are more than one similar place, but sealed with a plug. Is it possible to move this outlet to the driver side? (I need exact on this position space for a bracket) Thanks!
  9. C

    7.3IDI newbie with a lot of questions

    Thank you. to 1. It was a heater for the cabin. But I would like to connect the main cabin to the motorhome heating system. Is there a drawing or explanation how to connect an heat exchanger to the engine? Mainly to extract heat from the engine cooling and put heat back for heating up the...
  10. C

    7.3IDI newbie with a lot of questions

    Hello, I bought a vintage chevy p30 motorhome with a transplanted 7.3IDI NA and an allison 545. I was a silent reader for a long time and now I have a few questions. 1. there was a coolant heating radiator for the cabin connected. It came somewhere from the block, through the radiator and...
See more

Latest posts

Forum statistics

Threads
91,262
Posts
1,129,487
Members
24,091
Latest member
freqencyheight

Members online

Total: 574 (members: 4, guests: 570)

Share this page

Top