Could you use one that had no straight on the 5" side? Basically a flare from 3 up to the 5 since the 5 is being welded it would not require a straight.
All I am wanting from him is the actual turbo, I have no need or want for the intake/filter boxes. Just needing it for parts for the one I already have, lol
Those are oversized tires which will throw your calculations for mpg off if you haven't changed the speedo gear. Might try doing the math back to see what your actual miles traveled vs the odometer and then figure it from there
Getting ready to order my brush research flex hone and want to make sure I get the correct one or ones if needed. I know its the 105mm or 4 1/8" but what grit or grits? 180, 240, 320? Aluminum oxide or silica carbide? Only doing a surface prep for new rings, cylinders are all dimensionally...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.