Recent content by 89_12valve
-
-
Welding Trailer(Best way to mount welder)
I will have to use them on the floor. My walls are a sort of composite board with wood beams... But being on the floor should still be secure enough with a ratchet strap. I will just raise my welder about 6 inches so oil changes and maintenance will be easier.- 89_12valve
- Post #7
- Forum: Towing and Hauling
-
Welding Trailer(Best way to mount welder)
Do you know where he got them from or can I get those at any hardware store?- 89_12valve
- Post #5
- Forum: Towing and Hauling
-
Welding Trailer(Best way to mount welder)
Its around 13 feet... Im going to have an air compressor up front, welder in the middle, and a manual tire changer in the back... It will be like a service call trailer(alot of citrus/trucking down my way) I was thinking of getting some eyelets that screw into the wood and use a ratchet strap...- 89_12valve
- Post #3
- Forum: Towing and Hauling
-
Welding Trailer(Best way to mount welder)
Hello all... I acquired an enclosed trailer(wood floors with beams) to haul my welder in. Its a Lincoln Weldanpower 225 with Wire Feeder, Converter Box, and Hi Freq box... I was wondering if anyone had any ideas on how to safely mount the welder and the other 3 boxes to the trailer safely. I was...- 89_12valve
- Thread
- Replies: 10
- Forum: Towing and Hauling
-
DS Vent
Is there a way to take off the DS vent located by the floorboard without taking the E-brake bracket off? Mine is leaking and I want to replace the felt seal with silicone.- 89_12valve
- Thread
- Replies: 0
- Forum: 1st Generation Cummins
-
Hello from Florida
- 89_12valve
- Post #8
- Forum: Introduction
-
Hello from Florida
Yes sir love to race :) I might try to see if I can fab a 5 inch CAT stack or use a 5 inch Bullhauler... I totally forgot about the diesels being low rpm grunts... I really dont wanna lose power over looks... Im all about functionality. Id rather have a few more lb. ft. of torque than more looks.- 89_12valve
- Post #7
- Forum: Introduction
-
Hello from Florida
Yes sir that has been addressed... Im thinking of putting a DRW rear end under it... Im half and half on the flatbed with SRW- 89_12valve
- Post #4
- Forum: Introduction
-
Hello from Florida
Hello all... Im from Arcadia, Florida.... Im new to the diesel world... Our familys first diesel was a 1983 Chevy C20 with the Detriot 6.2... I was still in diapers then. Our family has been racing for 60+ years and I carry on the torch so I needed a truck I could haul race cars, haul my welding...- 89_12valve
- Thread
- Replies: 7
- Forum: Introduction
