1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
aggiediesel01

IMG_0802

IMG_0802
aggiediesel01, Feb 13, 2020
    • aggiediesel01
      Gpop's instructions say that for right hand thread shafts, run the nut down until it touches and then go 1/4 turn more. That felt pretty tight to me but it made my balance marks line up so it must be pretty close. Of course check the whole assembly for smooth rotation now before the thread locker hardens up. Take the assembly out of the vice and presto that's about it!

      That's basically it for reassembly. Now you can wrestle with the compressor housing oring to get it seated and put the clamp bars on. Good luck!
    There are no comments to display.
  • Album:
    Factory Turbo/ATS 093 Rebuild
    Uploaded By:
    aggiediesel01
    Date:
    Feb 13, 2020
    View Count:
    219
    Comment Count:
    1

    EXIF Data

    File Size:
    1.5 MB
    Mime Type:
    image/jpeg
    Width:
    3264px
    Height:
    2448px
    Aperture:
    f/2.2
    Make:
    Apple
    Model:
    iPhone 6
    Date / Time:
    2020:02:13 00:23:25
    Exposure Time:
    1/30 sec
    ISO Speed Rating:
    ISO 40
    Focal Length:
    4.15 mm
     

    Note: EXIF data is stored on valid file types when a photo is uploaded. The photo may have been manipulated since upload (rotated, flipped, cropped etc).