Search results
-
N
6.2 ignition intermittent click
Any 6.2 guys here who can give me a hand? So we got the 84 6.2 suburban running again a couple weeks ago...after replacing the fuel filter with a racor setup we were priming it and thought we burned out another starter. We replaced the starter only a few days before to fix the truck and so we...- ncidi
- Thread
- Replies: 3
- Forum: 6.2L Diesels
-
N
6.5 running loud and rough
Unhooked the optical sensor and it wouldn't run, so that makes me believe it is something else.- ncidi
- Post #11
- Forum: 6.5L Diesels
-
N
6.5 running loud and rough
The truck runs fine on the road, it's just at startup. The truck has been ran on biodiesel produced locally. I will continue to keep an eye on the injection pump though- ncidi
- Post #9
- Forum: 6.5L Diesels
-
N
6.5 running loud and rough
Going to pop test the injectors within the next couple weeks once I can get around to working on the truck. The truck has been great up until this point, not a single issue at all.- ncidi
- Post #7
- Forum: 6.5L Diesels
-
N
6.5 running loud and rough
Don't have an exact mileage, they were replaced before I got the truck at 235k, it has just over 250k now and I believe the PO said he replaced them between 180k and 220k- ncidi
- Post #5
- Forum: 6.5L Diesels
-
N
6.5 running loud and rough
Pulled the codes today, and here's what I got. Checked the codes and got 17, 18, 34, 35, 36, and 78. I read up on them but I still have no understanding of what half of this stuff is. 78 I'm guessing is out of the window since the truck has a homemade boost control setup. The only other mod is a...- ncidi
- Post #3
- Forum: 6.5L Diesels
-
N
6.5 running loud and rough
94 6.5 suburban randomly wouldn't start. It would crank over fine and would eventually start, sometimes 5 minutes, sometimes 5 hours. Replaced the pmd, tried unplugging the optical sensor, and neither made a difference. When it does start, it is very loud (can hear it in the video) and when it...- ncidi
- Thread
- Replies: 10
- Forum: 6.5L Diesels
-
N
Nissan Ld28 guys?
The gasser guys use the crank from the diesel for a stroker motor, so I would guess the flywheel should work except that I have heard this may reduce the diesels down low torque- ncidi
- Post #4
- Forum: General Diesels
-
N
Nissan Ld28 guys?
Awhile back my dad and I pulled a great running ld28 out of an old maxima wagon we had laying around and have been throwing around ideas of how to use it...looking at a small jeep or 240z/280z only problem was the car was an auto and we scrapped the transmission and we want to find a 5 speed...- ncidi
- Thread
- Replies: 5
- Forum: General Diesels
-
N
custom ranger swap
Another good option is just pick up one of these like I did. 1986 Isuzu trooper 2, 5 speed factory turbo diesel with a naturally aspirated motor out of a Isuzu pup swapped in for the better internals...gets around 30 mpgs around town and low 20's bashing it off road.- ncidi
- Post #13
- Forum: Diesel Conversion Forum
-
N
WTB- Idi/manual F-350 4x4 near Asheville, NC
Bump for a truck for sale?- ncidi
- Post #3
- Forum: Marketplace
-
N
WTB- Idi/manual F-350 4x4 near Asheville, NC
Bump...anybody with a rolling chassis even? Don't even need a whole truck.- ncidi
- Post #2
- Forum: Marketplace
-
N
WTB- Idi/manual F-350 4x4 near Asheville, NC
Hello, I'm looking to buy a 6.9 or 7.3 idi 4x4 F-350 near Asheville, NC but I can travel 100-150 miles for the right truck. Needs to be a manual 4 or 5 speed. I'm fine with either a single rear wheel or a dually. This truck will be the start of my Jeep J20 diesel project so I don't care how bad...- ncidi
- Thread
- Replies: 2
- Forum: Marketplace
