Search results

  1. 4x4manonbroke

    Inside tire wear on Dana 60

    A shock will allow the tire to cup by allowing the tire to bounce down the road causing a cupping action on the tire .. feathering also can happen .. The issue can be ball joint or toe adjustment ..
  2. 4x4manonbroke

    and then she ran away.....

    a 5lb CO2 extinguisher would do the trick fast !!!
  3. 4x4manonbroke

    Turned up the Fuel and time it, I should a done this earlier!

    yeah I have mine turned up 3 flats .. but I'm N/A as well .. really woke it up ... after I get done with the HG's and wiring and such .. then I will time mine as well ... What are y'all running ... 9* sounds good ... what seems to work for the N/A engines ? are the turbo engine's more...
  4. 4x4manonbroke

    Oil pan removal while engine in truck **HOW**

    I have always just pulled the trans out and lifted engine straight up ... pita but its less time consuming than all the other ways of doin it that I have seen thus far ... mine have also only been N/A not turbo'd ... :mad:
  5. 4x4manonbroke

    Fuel filter options?

    I run wmo and ATF in both my mechanical Diesel trucks .. I run a BIO-Glass filter ( all the oil is previously filtered to 5 Microns 2 times put through filters..) and then it all gets re-filtered on the trucks before going into IP.. I can get 55 gallon drums of oil for free, in the summer I mix...
  6. 4x4manonbroke

    Noisy drivetrain

    Check diff also ... the noise can and will travel up the drive shaft .. start checking for loose yoke's , make sure hubs are disenguaged.. etc..
  7. 4x4manonbroke

    H1 Hummer beadlocks

    Looks awesome guys ... Now I'm thinking about doing this too ... HUmmm !!
  8. 4x4manonbroke

    head gasket failure

    These engine have weak head bolts and the new HG's are updated, the old ones usually leaked oil.. I also plan on doina a re-torque after I get the engine back in the truck just to ensure that all is tight ..
  9. 4x4manonbroke

    1994 2500 rear axle

    mine is about 3-3.5 hrs away
  10. 4x4manonbroke

    Loss of power when driving

    low fuel pressure, IP timing
  11. 4x4manonbroke

    dmf / clutch

    Go with the Single flywheel .. those DMF are junk even new ... done at least 4-5 swaps .. just new flat flywheel, clutch to match, done .... the ZF5 is just fine behind a single mass flywheel , no worries
  12. 4x4manonbroke

    fan clutch removal

    O too have had a few that were junk, I used a torch to just cut the nose of the hub off, then I was ablt to get on the big chunk that was left with a gun ..
  13. 4x4manonbroke

    Cummins in a 1994 Ford F350

    any progress here ?
  14. 4x4manonbroke

    1994 2500 rear axle

    Bummer to hear that .. dont get to see mine real ofter either ..
  15. 4x4manonbroke

    Brake Bleeding???

    You push down and hold to get the "Air Bubbles" to move out of the system, if you just pump if and then go bleed, your not doing anything .. I use a small 2x4 place it between seat and the brake pedal.. I did my truck alone, brakes work just fine ... If you need to "Pump" the brakes, you could...
  16. 4x4manonbroke

    unexplainable issues.

    I mentioned it because aluminum and brass deteririate so rapidly, Copper is the next best thing , thats why they use it ... if you put aluminum under the injector you would need to re-torque the injectors frequently ..
  17. 4x4manonbroke

    A little more power cheap or easy?

    I agree, Your dead on !!!! if the Pyro is behind turbo He's nearly melting a Piston pulling hard up hills .... Need to get a better idea of where the pyro is ..
  18. 4x4manonbroke

    A little more power cheap or easy?

    I Agree, Its not a cummins truck, and slow down to 62-65, my truck hates pulling faster than 62-65, unless were about to hit a big long hill, then I plow it up to about 75 and let the hill drag me down... With that said , I did pull an Excursion (6.0 blew up .. go figure) .. trailer and all , it...
  19. 4x4manonbroke

    Finally having some IDI fun!

    Looks like an awesome project.. what year is the IDI you using ?
  20. 4x4manonbroke

    unexplainable issues.

    Some rust is not really uncommon , A bit of fuel, and some moisture, not a big deal, clean it out real good , if you can get a small wire brush - and some brake clean ..
  21. 4x4manonbroke

    Fuel mileage

    Good to hear , What led you to the TPS ?
  22. 4x4manonbroke

    unexplainable issues.

    Were talking about injector copper washers .. ? Brakes ? :confused:
  23. 4x4manonbroke

    1994 2500 rear axle

    LOL.. I have a friend who drops his off and takes mine while i fix his ... trust there .. ( his is nicer too ) ..
  24. 4x4manonbroke

    1994 2500 rear axle

    OMW ... yeah either a wheel bearing or a U-joint has locked up ...
  25. 4x4manonbroke

    1994 2500 rear axle

    Good thing its able to be driven daily .. walking sucks

Forum statistics

Threads
91,217
Posts
1,128,479
Members
24,045
Latest member
Ramtough01
Top