Search results

  1. S

    lost boost whats wrong was getting 38 now only getting 20

    we need more info, is the truck real smokey or clean? Check the boots in the ducting to and from the intercooler to see if one has slipped.
  2. S

    V-8 Cummins

    Yup, everyone is entitled to make mistakes as long as they learn from them! But unfortunately some still haven't learned from theirs :draw ;p
  3. S

    plug location

    look @ the bottom of the fan shroud on the right side.
  4. S

    And the Saga Continues - Need More Help

    I found this thread tonight so I am not fully in the loop but Oil pressure is at its lowest point @ idle, if the light is on above idle and not @ idle it could be a bad sensor. or there is something else entirely wrong that the dealer can't or won't find to fix this.
  5. S

    Flatbed Trailer bow

    My guess is so that the trailer deck is flat when loaded beyond that I have no idea.
  6. S

    Does anyone have this picture?

    the Kore kit lifts the rear about an inch and that with between 2.5"-3" on the front, the truck will have a slight downward stance in the front. I am looking to get the Kore Chase system for mine.
  7. S

    Does anyone have this picture?

    Try Gale Banks Engineering for the pic since the truck is theirs.
  8. S

    Outlook Monitor Installation

    the one labeled pyro#2 that is hooked with the nut and bolt is for a second pyro probe and need to be hooked as they are if they are not hooked to a probe. as to the rest I can't help.
  9. S

    Ford admits the 6.0 sucks..................

    Do you know that the 6.0 has been in service for several years @ 250 hp in other applications and was relatively problem free. It was FORD that screwed with it and caused all the problems because the had to keep up with the jones's(dodge, chevy) in the HP wars. And BTW they are doing the same...
  10. S

    Radator went

    I think there is a TSB for this, if I remember correctly the fan control harness will rub a hole in the rad.
  11. S

    Brake lights stuck on

    check the brake switch 1st. then try unplugging the brake controller if you have one. Mine would just arbitrarily come on by themselves with no one in/around the truck, and I disconnected the brake controller and no more uncommanded lights.
  12. S

    jeep YJ 6.2 conversion

    The 6.2 SHOULD be identical to the S/B Chevy in regards to the the bellhousing and motor mounts. The pilot bearing shoulde be the same also. But the motor is physically taller and wider and possibly longer also so it might be difficultto get it to fit. why not juststick a gasser in there?
  13. S

    4.7,5.9,V10 or Hemi's

    I have a millenium edition Durango SLT+ w/ a 4.7L. It is 4wd with 31/10.5R15's, I know it gets around 12 mpg. in town. I get better mileage with my truck so I don't know what kind of mileage it gets on the interstate.
  14. S

    5in exhaust

    on a stock truck you will lose some power. they don't need any more than 4" until 500 hp. my '03 ETH/DEE dynoed @ 250 with a 5" exhaust and Drop in air filter. It should have been closer to 270.
  15. S

    Switching to Dodge

    the 6 spd also has a bigger diameter clutch (13") but the clutch is weaker @ high HP but aftermarket is better for the 6'er. trackbar on the 4wds is junk.
  16. S

    Should I buy this?

    if they used the old key with the new pump it will show a problem. the pump comes with a key and they must match.
  17. S

    What does your truck run?

    my best run was 16.55/86mph in the 1/4 with a clutch slipping 6 spd and stock turbo on 35" tires. I got those problems fixed but can't find a 1/4 track now.
  18. S

    How well does the 6BT or ISB motors run on bio diesel?

    I've run my ISB-E on b2 and could not tell a difference. Dodge and Cummins don't recommend above B20 but people have run higher concentrations with out problems.
  19. S

    Tire size

    stock SRW rims will work fine with the 315's w/o the spacers. I know a guy that had 315's on a hemi @ stock height carrying a 1000 lb. snowplow. they will rub on the control arms even with the leveling spacers. What is the backspacing on the rims you are looking at, if it is not close to stock...
  20. S

    Dealership screwed up bad!!!!

    If they are so pissed about it tow it directly there and ask where all the coolant went if they had done their job and filled it like they were supposed to! And I would involve the OWNER of the dealership! I would also get in writing that if ANYTHING goes bad down the road related to...
  21. S

    Serviceing..............

    I would rather pay for and replace mine than the new 6O-No's filters!
  22. S

    Friend wants a Ford

    I think that it is an IDI or turbo IDI, I was told that the powerstroke wasn't available until '94
  23. S

    5 speed gearshift lever questions...

    I don't think the insert can be purchased individually, I think you have to buy the whole knob.
  24. S

    5 speed gearshift lever questions...

    look at a Ranger 5 spd for the knob or the knob from a DODGE 5spd as I think it will also fit your knob. you are right about the shifter, it is to suppress vibration in the lever.
  25. S

    Damn it I got the vibs.

    the driveshaft is two piece right? the carrier bearing is also a common culprit for this
Top