Search results

  1. onebadiditurbo

    Read seat swap.

    Ok ive searched but im not wanting to do the usual superduty swap. Simply what id like to do is install the extended cab folding seat in place of my rear seat in my crew cab. I dont have one handy to look at the mounting brackets so can anyone tell me if the cc cab will accept them ?
  2. onebadiditurbo

    Clutch turned direct drive.

    Ok so depress clutch at red light, noticed a slight noise that quit, put trans in neutral like usual, went to take off and couldn't get it in gear. Drove 40miles w/out clutch and begin work. 1st I noticed some slack so I replaced the clutch master cylinder so i could eliminate the slack in the...
  3. onebadiditurbo

    Charging problems

    My 1994 f350 with the 7.3 Idi, I drive this truck nearly daily and keep an eye on gushes so it's a new problem. I get in it start it all seems normal, turns over fine and starts, battery guage fluctuates while GP's cycle, usually it jumps to normal after they stop but it didn't this time. I...
  4. onebadiditurbo

    Sudden Oil cooler leak

    Ok oil cooler suddenly sprung a leak during this cold snap. It's on my 94 7.idi. it's leaking out the rear header bolt hole. It's just leaking oil to the outside in about a 1/4 size stream, it's not mixing coolant. Any quick temp repair, I can't really afford for the truck to be down right now...
  5. onebadiditurbo

    Sticking valve or heat soak

    Ok what you guys think heat soak of something sticking in the IP. My truck will start fine cold/cooled off and if you start it within 15mins or so after its warmed up but any longer and nothing. Just crank and crank but will start immediately if you pull start it. I've let it set 2hrs before and...
  6. onebadiditurbo

    Looking at a new truck

    Ok guys I've found a 2004 f250 with the 6.0psd. It's had larger fuel lines installed, egr deleted all done by the previous previous owner. This guy isn't sure if it's been studded. It's only got 109k. What's the purpose of larger fuel lines? What else should I ask about it or look for. Thanks.
  7. onebadiditurbo

    I need a Injection Pump guru

    I've been having intermittent issues but did the injection return lines, new rubber hoses, new fuel filter and replaced glowplugs while I was there. I've also been running 2stroke oil religiously since and haven't had any major issues other than her usual contrary crap but today I had my ole...
  8. onebadiditurbo

    No start hot turned to intermittent hard start

    Ok I previously had a no start issue, hadn't done injector return rebuild in awhile so I figured I'd go ahead and rule that out just to be sure, but with the help of you guys thinking it was the shower head in the fuel tank. Anyway got the kit installed for the injector return lines and it...
  9. onebadiditurbo

    Killed truck then no start.

    ...killed truck went and ate came back outside and it wouldn't hit a lick. It turned over fine, no wet injectors caps(replaced about 8 months ago) so no obvious air leaks, have 12vdc to the FSS on the IP. Now when I pressed the Schrader valve on the filter head fuel did not come out, rather a...
  10. onebadiditurbo

    LUK LFW 128

    Ok clutch went out, replacement didn't fit, come to find out it been swapped to a solid flywheel...Luk LFW 128, I haven't been able to find a replacement, and drawing blanks on google, it's a 12.25" disc, and ideas where to look or partnumber would be awesome.
  11. onebadiditurbo

    Allison Transmission leaking bad.

    Need some help. 2004 chevrolet 2500 HD 4x4 Recent flooding here in North Tx. Forced me to drive thru some water to get home. I noticed I was leaking some kind of light black oil all over the place. It looked like where the transfer mounts to the tailshaft adapter. I pulled the transfer last...
  12. onebadiditurbo

    ISO 7.3L IDI Headers

    I'M looking for a set of stans headers or equivalent. Anybody have a set you want to part with let me know.
  13. onebadiditurbo

    rear hub caught fire

    So my rear hub evidently got so hot it caught fire when I stopped. I drove about 60 miles before realizing I had a problem. I hit brakes and didn't have much pedal. Pulled over to check it out and it was on fire. I think the parking brake stuck and I just didn't realize it. What kind of damages...
  14. onebadiditurbo

    Heat radiating from floor

    Hi I've got a 94 f350 CC SRW 4x4. For some reason I'm getting a lot of heat under dash area with setting to cool. My ac and vent works it changes from floor to defrost to vent is there something that happens that's common to failure?
  15. onebadiditurbo

    WTB 7.3 IDI Parts

    I need a complete CDR for a non turbo truck, a driver side valve cover from a non turbo and also a air cleaner assy.
  16. onebadiditurbo

    Chunks from turbo

    I recently bought an ats 088 turbo system and installed on pickup. Previous owner said a 60-1 wheel was installed but didn't think it was balanced. I installed it and had a oil leak 2qts in 11miles. So I pulled it for inspection found a slight bit of oil in compressor side of turbo and oil in...
  17. onebadiditurbo

    ATS 088 turbo exhaust housing

    I'm in need of an exhaust housing for ATS 088 system. During disassembly two bolts broke off in mine. I have a rebuilt center section for replacement but can't get this one to separate. Does anyone have one they would sell?
  18. onebadiditurbo

    loss of oil pressure

    My 94 f350 with 7.3l Vin k has 205k miles. Problem happened last weekend drove about 100 miles to go riding atvs so was pulling flatbed 4 wheelers ice chest couple cases of beer and 3 other people. No problems getting there leaving on the other hand bout 10 miles into it i noticed the oil...
  19. onebadiditurbo

    upgrade turbo housing and down pipe

    Im looking for the ats upgraded turbo housing and down pipe or someone to modify upgrade the one I have. If you know of anyone who has one in stock or to get rid of or has done this kinda thing let me know. Thanks
  20. onebadiditurbo

    ATS turbo housing and downpipe or homemade available anywhere

    I really want to upgrade my exhaust on my factory turbo. Does anyone know where I can get a ats housing or know anyone making something compariable. I dont care if its homemade as long as it quality.
  21. onebadiditurbo

    Strange Glow Plug Operation

    Ok I can park my truck long enough that it cools and the gp controller should kick on and it doesnt. The light just flashes. I can crank the engine over for a couple seconds and it works fine. been doing this for about a week now and its consistent with the cranking. Ive tried just cycling the...
  22. onebadiditurbo

    Stuck Glowplug and stuck Injector.

    On had a cold start issue in a previous post. My bad glowplug i had was the one kinda under the turbo on the passenger side. Got it loose and it wouldn't come out so i decided to pull that injector to get a little more room and i only got half of it out. The tip part stuck in tge head. So my...
  23. onebadiditurbo

    Cold start issue. Could use a little advice.

    OK its finally getting cold enough in Texas to have problems. When I first try to start truck the wait to start light just flashes for a second then goes off. I usually just wait for the afterglow cycling to stop and haven't had an issue until now. I checked all the glow plugs with a test light...
  24. onebadiditurbo

    WMO questions and suggestions

    OK I made my first batch of wmo to run in my 94idi turbo. I left diesel in one take and put wmo in the other. My mix was 85%oil 15%gas 1oz cetane and acetone per 5gal. When I first switched the tank it acted like it ran out of diesel my reving up a little. It seems to run fine on it but its...
  25. onebadiditurbo

    Need used starter for 7.3l idi

    I just need a used starter for a idi motor to turn in for a core. Some drugie stole mine out of the back of my truck. If you have one let me know asap.

Latest posts

Forum statistics

Threads
91,266
Posts
1,129,521
Members
24,094
Latest member
madmustang1965

Members online

Total: 448 (members: 5, guests: 443)

Share this page

Top