Search results

  1. S

    1992 Ford F-250 with 7.3L ATS Turbo

    http://eastidaho.craigslist.org/cto/4259311909.html http://boise.craigslist.org/cto/4259308677.htm
  2. S

    For Sale 1992 Ford F-250 7.3L

    After almost 18 years of driving her, it is time to move on and I need to find a good home for my 1992 Ford F-250 7.3l. As of right now it has approximately 185000 miles, new batteries as of Nov, all new glow plugs, new water pump and r-134A conversion summer of 2012, tires have good tread...
  3. S

    Thermostat Gasget

    Anyone got a pic and part number for the correct thermostat gadget. The one they gave me is wrong and the old one came out in pieces. Thanks
  4. S

    Fan clutch removal

    Trying to get my fan clutch off to change water pump. I have the loaner tools from the local parts store and am having no luck. But to be sure while standing looking at the truck I am trying to loosen that nut by pulling the tool to my left/passenger side of truck????
  5. S

    Road trip postponed, water pump leaking?

    Got A/C fixed yesterday and getting ready to leave fire truck up this morning and notice that it is dripping water. I found that the water drops are falling off the engine at the crank shaft? Is this a my water pump leaking? Already put leak stopper in it months ago for another issue. If it...
  6. S

    Help!!! Working on A/C right now and am confused???

    A/C fixed now... Got it all straightened out and everything seems to be where it should be low side 35 high 215 psi. Good to go thanks for all that chimmed in!!!!!! Road trip will be much more enjoyable. Thank You How many cans of 134 should the system take?? I have three 12 oz cans in...
  7. S

    High and Low sides on A/C

    Just to be sure before I proceed any further, the lower pressure a/c port is the one that is directly on the dryer its self???? And the high pressure is the one on the drivers side pretty much right next to the battery? This is standing in front of the looking at the engine.
  8. S

    Another A/C question

    Doing the conversion to 134 and have cleaned replaced and oiled everything according to all the threads on this forum....Thanks! However To make sure it is right I want to check the clearance on the compressor and clutch. Is this checked in the small space between the pulley the belt rides on...
  9. S

    Starter Clicks

    Replaced my started little over a year ago with the one in the picture. About six months ago when I would turn the key over you would jus hear a click, try it again and it would start. Well now today when I turn it over it just clicks every time I turn the key over. I cleaned all battery...
  10. S

    Power Steering Gusher

    Its -21 below zero here, so I needed to move the truck to spot where I could plug it in. Hook up the fork lift start moving it and all the sudden power steering fluid starts pouring out. What could be the problem? Could this issue go away once the truck warms up or did I bust a seal when i...
  11. S

    Oil Leak??

    Finally get the truck starting like new, the thing started this am in -30F wind chill like it was brand new. Then like always someting else goes wrong, all the sudden out of the blue while it idleing its starts leaking oil down the drivers side. the oil is coming out down somewhere from the...
  12. S

    Hypermax Cowl Induction Installation

    Just recieved my hypermax cowl induction and was wondering if anyone had any tips of tricks to the installation, pretty straight forward. To use sawzall or tin snips of firewall??? thanks
  13. S

    HELPPPPP!!!!!

    Please help in the middle of changing gps and the number 3 cylinder gp will not thread all the way down. I stripped the hex on the first one, got it out and have threaded the old one back down a bit but it too, will not bottom out? Any help please?? also any ideas to get the ones under the...
  14. S

    Super Hard start after repairs

    I just got done replacing all the caps, o-rings, and return fuel lines. I also had to put in a new injector and #5 injector line. Oh, and had to replace 2 gps. Went to start is am and it kind of started then stoped. I had to crank and crank forever before it stumbled and finally started. The...
  15. S

    Intake Hat, Down pipe. Boost leak

    How does one get the intake hat off without removing the compressor side of the turbo on a gated ATS? I can not figure it out? I need to get a new seal in there. Also might need a new seal in the area where the compressor connects to the intake hat. On the firewall right behind the downpipe...
  16. S

    Glow Plug test

    I have been having some glow plug testing issues. I am getting readings all over the board. I have set my ohm meter to the lowest setting 200. When i test the plug i get 34.5 and then .02 depending on how hard i place the tester ontop of the plug as well as where i place it and the negitive...
  17. S

    Questions

    I need a little guidance. I am in the middle of tracking down a fuel leak and determined that is is coming off the return line out the top of the ip. Started on it tonight and found that most of my return lines have what appears to be cracks in them, so new return line kit is in on the way...
  18. S

    fuel line size

    What is the size of the return line fuel hose? I need to pick some up on my way home tonight and forgot to bring my sample with me. I was thinking bout getting enough clear line to do my entire return system. Anyone see a problem with this???
  19. S

    Diesel Down-Major Fuel Leak

    Im at a loss right now, my pickup is down with a major fuel leak that I can seem to find. Right now fuel is dripping down at the rate it takes up a square foot area in bout 5 mins. The fuel is dripping down off the bell housing, starter, and then coming off the oil pan. Fuel filter is tight...
  20. S

    Lots of White and Grey smoke on cold start!

    When I start my truck in the morning even with it plugged in, after i crank it for about 3 seconds it fires but runs really ruff and blows massive amounts of white and grey smoke and shakes horrifically. After bout 10 seconds it smooths out and runs fine. I noticed that my return line of the...
  21. S

    Brake and Power steering flush? How to?

    What is the simpliest way to flush the brake, clutch and power steering fluid. Its been years since this was last done. One other question, what would cause my truck to pull hard to the left when i stomp on the brake peddle?? If i got weight on the truck it will damm near pull me off the road??
  22. S

    CAT ELC

    So a read on another thread that residule water in the system when used with ELC will cause sludge?? If i mix the system 4 gallons CAT ELC concintrate with 4 gallons distilled will i have a problem??
  23. S

    Coolant Flush

    Anyone got the link for the steps to coolant flush, saw it sometime back and cant find it. Gonna do the flush this weekend along with coolant fliter install.
  24. S

    Vacuum Control Motor

    The vacuum control motor that is mounted on top of the heater core for the AC recirc, what is the part number or a good replacment i cant find one anywhere!!!
  25. S

    Need real part name!!!!???

    What is the name of the vacuum actuated thing that is on top the heater box in the far right cornor of the the engine bay??? I think it controls the recirculation door on max ac and off????

Latest posts

Forum statistics

Threads
91,376
Posts
1,131,347
Members
24,174
Latest member
MadScientist

Members online

Total: 496 (members: 4, guests: 492)

Share this page

Top