Not sure if it matters but I have no fuel in the oil and every time I cleared that cylinder through the glow plugs hole it knocked the valve cover over with the residual oil in the cylinder.
Quite a bit. To be honest I don't notice any difference in blow by, but I could be wrong. I always thought there was a lot of blow by but the motor always ran strong.
I bought one that said it would do a 7.3 but it wouldn't do the job. Need one specific to the 99' and up so I've been told. Have I been misinformed? I am ordering one tomorrow so I should know. Runs good smooths out at 1300 rpm but still low on power. No noise other than the thump thump of a...
I probably shouldn't have done this but I also tied a jumper wire from the IDM harness to the harness just before the plug to the gasket/ harness. No change. I then wired the new harness plug that came with the new gasket into the harness. No change. The IDM I purchased ,I actually drove three...
Ok, back in town. Truck fires and runs but I got two injectors not firing. 3 and 4. I switched injectors around and it's not firing the proven good injector. Changed the new valve cover gasket/ harness for fear it was bad out the box. New harness still not firing 3 and 4. So I'm thinking IDM...
Ok, got it to fire again. Ran it for half an hour doing some WOT hits. Clears up over 1500 rpm. I let it idle for ten minutes. Still idling rough. Stuck my hand in the front wheel wells driver side was pretty hot but passenger side was cold. Put my hand right on the manifold on all four. Cold. I...
Got it to fire off and run. It's still not right. It will rev up. Only clears up at 1300 rpm and up. Will idle but rough. Won't rev down to an idle but I can start it with no throttle and it will idle but rough. I have had a bit of experience with gas motors and it acts alot like cam/ crank...
It's changed often. I had changed it recently but I will change it. Stupid to run used oil through new injectors anyway. Sounds even dumber when I read it.......
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.