Well i received my Motocraft glowplugs and new filter yesterday. I also ordered a reman IP from Uhaulparts.com. Frank is very nice. It also came yesterday. Had time to put the glowplugs in and try them. It starts alot better but you still have to crank for about 4 seconds till it catches and...
Diesel JD I did get all the glow plugs out. I used a 1/4" cordless drill on the autolite. I chucked the end of the plug into the drill and unthreaded the plug. Then turned the drill and pulled very gently and it came out. Lucky and learned a lesson. I think i cycled the plugs one to many and...
When all there is available borsch our autolite over the counter and you only need one. To see your truck will start for the first time and you having been working on installing to motor for 2 weeks. Remember I have never owned an IDI motor ever and I don't ever expect to be an expert. I usually...
It has been in the 30's. It kinda of strated ok but at the first but I really don't have any good strating history. ( meaning I have been fixing all the little things) bad wiring, bad glow plugs,no check valve at the filter and so on. I have been chasing my tail on this for 2 weeks. I think I...
I have read most everything in this forum for the past week and need a little help. I need to know if the voltage readings on the controller that I have sounds correct. Also If i have miss matched plugs will that have an effect with the controller.
I have a 1991 F350 4X4 dually flatbed 7.3, 5...
I glanced through the FAQ and went through all of the tech articles. I already did the clutch rod heim joint end project. Turned out excellent. Great site.
I am down to the glow plug part of the motor. I started with the controller. All the wires are connected correctly and have a good clean tight connection. The batteries are at 12.34 volts and that is what i have at the battery side of the controller. The wires were melted at the plug and I...
I am sorta new to this forum. Yes I my self bought a 7.3 IDI truck and of course not running. Started reading this forum right off the bat to gain as much knowelege as I could to bring my new project to life. So I get all caught up in tearing apart the truck. Now reassembling and having all kind...
You are correct. I was looking at the wrong problem. I took the fitting off the filter and it looks like a barbed 1/4 " hose fitting. I don't think it was ever a check valve. I am new to this truck and motor. (just purchased it not running) Then bought a supposedly rebuilt motor. Just installed...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.