Recent content by GunnerJ

  1. GunnerJ

    Electric issues 93 6.5

    Oh boy. Thank you, I'll start there Sent from my VS987 using Tapatalk
  2. GunnerJ

    Electric issues 93 6.5

    I was not hoping to hear that, its a 93 Sent from my VS987 using Tapatalk
  3. GunnerJ

    Electric issues 93 6.5

    I ended up trading into a 6.5, and overall I'm pleased. There is a big issue with the wiring however (I believe). When it's been sitting overnight, it blows a guage fuse without fault. When I put it in reverse, my panel lights and radio and sometimes even my blower controls flicker. Sometimes my...
  4. GunnerJ

    Dynomax exhaust?

    Doesn't matter either way, the day of the trade the guy texted me saying he sold it [emoji35] Sent from my VS985 4G using Tapatalk
  5. GunnerJ

    Dynomax exhaust?

    There is a guy with a brand new in box 4 inch exhaust setup that I might be trading for($200) trade value. How are those systems? Will it give new a noticeable increase in power? I'm currently running a completely stock setup. How much louder? Will I need to adjust the ip slightly to account for...
  6. GunnerJ

    Bringin home the kids truck

    My first truck was a 2wd Mazda b2200 with a little 4 banger haha, I sold it and an extra motorcycle for a....ahem....jeep....and then I traded said jeep for an 89 Bronco on 35s, which I traded fur the truck in my sig/profile pic. I would love to have an old Ford like that, it's plain badass in...
  7. GunnerJ

    Rough hot idle?

    Slightly lean on idle? Is your lift pump mechanical? It seems to me that if it was getting tired you wouldn't be getting enough pressure to feed the ip until you got some rpms behind it, but I don't know. Maybe your timing very slightly off? Sent from my VS985 4G using Tapatalk
  8. GunnerJ

    55 Buick Cummins swap. The Bummins

    Dang, I was going to compliment you on your nice bum but it's gone by the wayside Sent from my VS985 4G using Tapatalk
  9. GunnerJ

    Hello From Idaho

    Welcome, I too come from the land of potatoes Sent from my VS985 4G using Tapatalk
  10. GunnerJ

    Looking at a 90 F250 7.3 IDI, have 2 hours to make decision, please help!

    My 16.5x12.3x33's did hit my front bumper on my f250, all I did was take a cutting wheel and cut out a nice curve on the front bumper. People don't notice unless I show them. Then about 4 months later I bought helper springs for the front and I bet I could fit 35s or maybe even squeeze 37s in...
  11. GunnerJ

    Turbo v non-turbo mileage?

    My 93 na with 3.55s and a zf5 sitting on 33 inch tires averages 18, but 97% of my driving is right at 55mph. Oddly, my mileage drops to 15-16 if I drive 50( the speed limit) Max was 22 during the winter time a couple of years back RIGHT after I replaced my injectors. Sent from my VS985 4G using...
  12. GunnerJ

    Help!! Annoying rattle/squeak when going over bumps

    I had a squeak right behind my cab for quite a few months that happened on bumps, drove me crazy until I figured out my grandfather stuck a 2x4 between the bed and the cab to keep the front of the bed from bending forwards with a camper in the back lol Sent from my VS985 4G using Tapatalk
  13. GunnerJ

    Zf noise

    That I do not know, it's had the same flywheel as when we bought the truck in 2004 Sent from my VS985 4G using Tapatalk
  14. GunnerJ

    Zf noise

    In my truck, the noise of the engine inside of the cab is much louder when I am in first and second gear, and the other three are much quieter. This is even true if I am completely stopped and just putting it through the gears as a noise test. Is it the same for you guys? It's been that way...
  15. GunnerJ

    One-piece front window/vent window eliminator

    While yes, bad seals are noisy and annoying, I do prefer the wing window for the ac capabilities in the summer [emoji14] and being able to crack a window without crap flying in Sent from my VS985 4G using Tapatalk
See more

Latest posts

Forum statistics

Threads
91,275
Posts
1,129,682
Members
24,098
Latest member
William88

Members online

Total: 516 (members: 10, guests: 506)

Share this page

Top