Hopefully I can get the truck in the shop in the next couple of days and check out the wiring harness and the return lines. I replaced all the return lines, orings and clamps about 5 years or so ago.
I had a couple of ZD9 plugs go bad last year. I ordered all new glow plugs(ZD9). Installed them, replaced all the bullet ends while I was doing these repairs. I also replaced the glow plug controller at this time. Previous to these glow plugs going bad my truck would start at 10 degrees as...
I just checked out the bushings. The sway bar is worn and it looks like a the rearward on the front springs are worn. Aslo the truck is occasionally making popping sounds under the driverside floor when turning.
Pushrod length on the master cylinder? I didnt measure anything on the master cylinder I just Swapped it and started bleeding brakes. This truck has never really had good brakes. But got worse when I had a line blow and I had to replace the abs valve and then the maste cylinder.
It looks like energy suspensions is the way to go. My big concerns is bolts. When replacing bolts in the rear suspension they all had to be torched. It looks like maybe there are two different size bolts in the front. I also think it is Interesting that they don't have metal sleeves on the...
I dontt think so on the hot brake fluid it does it even when you start the truck. I can stop the truck you just have to push the pedal almost to the floor. If I adjust the rear brakes anymore the rear wheels get a little grabby.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.