F350,250? 460 GASSER MOUNTS

IDIoit

MachinistFabricator
Supporting Member
Joined
Aug 26, 2014
Posts
13,318
Reaction score
3,879
Location
commiefornia
whos got a set of the cups that riveted/bolted to the frame for a gasser engine?

i know 460 plates will work, i dont know if there the same for small displacement engines

did you take them out for your diesel swap?

still have them around?

yea, ive had a few sets myself, but ive always scrapped them :/

now i need to put a 460 on my engine run stand.

needed ASAP.

helpmeobiwankenobiyouremyonlyhope
 

FarmerFrank

Full Access Member
Joined
Sep 5, 2013
Posts
1,364
Reaction score
59
Location
Blairsville, Pa
Man oh man, your order just keeps getting bigger. If I remember tonight I'll take a look for them. I know I have a set of them somewhere.


Sent from my iPhone using Tapatalk
 

IDIoit

MachinistFabricator
Supporting Member
Joined
Aug 26, 2014
Posts
13,318
Reaction score
3,879
Location
commiefornia
besides kids, building and driving trucks, cars, and boats... ordering parts is my favorite pasttime!
 

dunk

Dunce
Joined
Oct 25, 2013
Posts
991
Reaction score
4
Location
NJ
Don't have frame perches. On my 460 truck I swapped from a small block and used conversion mounts with a single stud. I have one solid pass side solid mount and I may have a torn apart drivers side or maybe even a used intact drivers side mount. Been through a few sets before I went solid and quit breaking them. Not sure if a single stud type mount would work on your stand?
 

IDIoit

MachinistFabricator
Supporting Member
Joined
Aug 26, 2014
Posts
13,318
Reaction score
3,879
Location
commiefornia
i have a cross member from what? i dont know, but its a 3/4 ton or better front x member.
i would rather not buy new mounts, or a conversion, because once its done, its getting changed up and put in a boat.
i have the mounts for that.
 
Top