Latest activity
-
SThis is what I am talking about; Go out and start your truck out in 1st gear and wind it up to around 2500 rpm, and then quickly drop...
-
Ssieg01 replied to the thread Best radiator hose clamp?.I like these clamps because they do their job equal and you can tighten them more. Extra nut may not be necessary. But since the bolt is...
-
SThats good information. When I rent out my timing meters I suggest timing these engines to several differnt degrees of advance. Its...
-
Ssieg01 replied to the thread Powerstroke 2 IDI no Turbo conversion.My idea is to rescue the broken IDI engine. I have no intention to go with HEUI. I want to stay mechanical. My problem is just, that it...
-
OOld Goat replied to the thread Best radiator hose clamp?.My 82 Datsun 720 KC had the OM 300ZX clamps when I bought it new. Never had a leak problem with them. Goat
-
Pesky worm gear clamp on the lower radiator hose at the radiator kept working loose. I happened to be at Harbor Freight and saw these... -
OOld Goat replied to the thread Rear main seal replacement.Hacked89 did have a good YT Video of installing the Real Main. Guess he took it down. I watched it several times before I installed the...
-
OThis is why I like to use a thin coat of RTV on both sides of most gaskets. It makes clean up SOOO easy the next time. The old gasket...
-
been wanting a e locker for several years now, And finally got around to it! made a short video about it as well -
-
david85 replied to the thread e locker 10.25.Nice job! As I mentioned on the other thread, the factory bulkhead connector is probably not worth the trouble. Using a heat shrink on...
-
Nero replied to the thread Linking gas tanks.Lots of semi trucks do this already. Just tap at the lowest point on both tanks and they'll level each other out. Only downside is you... -
love it, just did the same on mine, and basically have seen all the things you have. the starboard was a nice touch!
-
david85 replied to the thread Factory Ford E-Locker Install.If I were to do it again, I’d probably just pass the wires through the gap for the gasket, with a couple of notches carved into the...
-
-
So I had an idea and I didn't know if it would work or if anyone else had tried it. So on my truck my Fuel selector valve doesn't work...
