Latest activity
-
WrenchWhore replied to the thread Powerstroke 2 IDI no Turbo conversion.When people are blowing up IDI's for fun I usually tell myself it has cavitation real bad and the block is cracked. Makes life a whole... -
If you have ton of power strokes available, and you like the cab and chassis, power stroke swap it. Sure it takes a little electrical...
-
I don't want to share how much I already payed for the F.O.R.D. since it is in my ownership. :cry: In the US you would probably say that...
-
Be happy it wasnt one of the high $$$ ones. I might shed a tear if one of my team ran over their optrel. Thatd be 800$ down the tubes... -
BBooyah45828 replied to the thread Self regulating glow plugs.It'd be nice if there was a simple controller that would screw in the coolant port like the 6.9 unit did, and then vary on-time based...
-
Be happy it wasnt one of the high $$$ ones. I might shed a tear if one of my team ran over their optrel. Thatd be 800$ down the tubes... -
ISPKI replied to the thread Cup holders.Be happy it wasnt one of the high $$$ ones. I might shed a tear if one of my team ran over their optrel. Thatd be 800$ down the tubes... -
I always gotta learn the hard way...this helmet was brand new-never been used and I hadda go and put it on the roof of 'Ol One-Ton...
-
SYou can swap all the guts to a 47 but there are some slight differences(gussets) in the 47 case that the 42 doesnt have
-
S2 gallons? WHY? It only calls for 6.8 PINTS or 3.4 Quarts. All you will do with 2 gallons is airerate the fluid and starve the bearings...
-
Well here it is. I'm going to discribe my fuel set up and as time and life progresses I'll share more, if y'all have any comments or... -
MMattbo replied to the thread Rear main seal replacement.Keep in mind these are both in the 1993 F-250 7.3 NA subsection, but if you look at the outer diameter measurements sleeve 99387 is...
-
-
MI was under the impression all IDI`s (6.9/7.3) were all the same. (as far as the Crank) maybe the 94, last year some changes were made...
-
MMattbo replied to the thread Rear main seal replacement.Ya I looked again at my order and it was for an F-350 same year same motor. After double checking outer diameter sizes it was definitely...
-
Fwiw, the width of the axle and tire sturdiness/capacity plays a part on stability. I went to #3860 tires first, then to a 5" wider...
