Forums
New posts
Search forums
What's new
New posts
New resources
Latest activity
Resources
Latest reviews
Search resources
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
New resources
Latest activity
Menu
Log in
Register
Install the app
Install
What's new
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Latest activity
What's new
New posts
New resources
Latest activity
B
Booyah45828
replied to the thread
Self regulating glow plugs
.
It'd be nice if there was a simple controller that would screw in the coolant port like the 6.9 unit did, and then vary on-time based...
8 minutes ago
DaveBen
reacted to
ISPKI's post
in the thread
Cup holders
with
Like
.
Be happy it wasnt one of the high $$$ ones. I might shed a tear if one of my team ran over their optrel. Thatd be 800$ down the tubes...
38 minutes ago
ISPKI
replied to the thread
Cup holders
.
Be happy it wasnt one of the high $$$ ones. I might shed a tear if one of my team ran over their optrel. Thatd be 800$ down the tubes...
48 minutes ago
ISPKI
reacted to
XOLATEM's post
in the thread
Cup holders
with
Like
.
I always gotta learn the hard way...this helmet was brand new-never been used and I hadda go and put it on the roof of 'Ol One-Ton...
50 minutes ago
S
screwhead
reacted to
Diesel_brad's post
in the thread
Quick Question Re: ZF5 fluid
with
Like
.
You can swap all the guts to a 47 but there are some slight differences(gussets) in the 47 case that the 42 doesnt have
Today at 12:52 PM
S
screwhead
reacted to
Diesel_brad's post
in the thread
Quick Question Re: ZF5 fluid
with
Like
.
2 gallons? WHY? It only calls for 6.8 PINTS or 3.4 Quarts. All you will do with 2 gallons is airerate the fluid and starve the bearings...
Today at 12:52 PM
dbg03
reacted to
Jesus Freak's post
in the thread
Jesus Freak's WMO tow truck
with
Like
.
Well here it is. I'm going to discribe my fuel set up and as time and life progresses I'll share more, if y'all have any comments or...
Today at 12:42 PM
M
Mattbo
replied to the thread
Rear main seal replacement
.
Keep in mind these are both in the 1993 F-250 7.3 NA subsection, but if you look at the outer diameter measurements sleeve 99387 is...
Today at 12:39 PM
M
Mattbo
reacted to
Old Goat's post
in the thread
Rear main seal replacement
with
Like
.
I was under the impression all IDI`s (6.9/7.3) were all the same. (as far as the Crank) maybe the 94, last year some changes were made...
Today at 12:31 PM
M
Mattbo
replied to the thread
Rear main seal replacement
.
Ya I looked again at my order and it was for an F-350 same year same motor. After double checking outer diameter sizes it was definitely...
Today at 12:31 PM
Nero
reacted to
u2slow's post
in the thread
DRW to SRW Pros cons discussion
with
Like
.
Fwiw, the width of the axle and tire sturdiness/capacity plays a part on stability. I went to #3860 tires first, then to a 5" wider...
Today at 12:26 PM
dbg03
reacted to
Jesus Freak's post
in the thread
DRW to SRW Pros cons discussion
with
Like
.
Duals look really cool....... And you COMMAND the parking lots. My truck started life as a single wheel one ton and at some point in...
Today at 12:18 PM
u2slow
replied to the thread
DRW to SRW Pros cons discussion
.
Fwiw, the width of the axle and tire sturdiness/capacity plays a part on stability. I went to #3860 tires first, then to a 5" wider...
Today at 12:12 PM
RSchanz
reacted to
BeastMaster's post
in the thread
Is it my alternator?
with
Like
.
I thought you put that to bed. Given what I see right now, I'm in Nero's camp. I found a wiring diagram for a 1G alternator. This...
Today at 12:05 PM
O
Old Goat
replied to the thread
So what did you do with your truck today?
.
Finally got the bed back on and bolted down. Fuel lines reconnected. I pulled it because front tank was leaking, really didn`t see from...
Today at 11:51 AM
Latest posts
B
Self regulating glow plugs
Latest: Booyah45828
8 minutes ago
6.9L IH & 7.3L IDI Diesels
Cup holders
Latest: ISPKI
48 minutes ago
6.9L IH & 7.3L IDI Diesels
M
Rear main seal replacement
Latest: Mattbo
Today at 12:39 PM
6.9L IH & 7.3L IDI Diesels
DRW to SRW Pros cons discussion
Latest: u2slow
Today at 12:12 PM
6.9L IH & 7.3L IDI Diesels
O
So what did you do with your truck today?
Latest: Old Goat
Today at 11:51 AM
6.9L IH & 7.3L IDI Diesels
Forum statistics
Threads
91,280
Posts
1,129,752
Members
24,098
Latest member
William88
Staff online
Griffin
Administrator
Members online
Nero
MethrenBlifs
Booyah45828
Cubey
Griffin
Mattbo
Share this page
Facebook
X (Twitter)
Reddit
Pinterest
Tumblr
WhatsApp
Email
Share
Link
What's new
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top