Latest activity
-
Be happy it wasnt one of the high $$$ ones. I might shed a tear if one of my team ran over their optrel. Thatd be 800$ down the tubes... -
ISPKI replied to the thread Cup holders.Be happy it wasnt one of the high $$$ ones. I might shed a tear if one of my team ran over their optrel. Thatd be 800$ down the tubes... -
I always gotta learn the hard way...this helmet was brand new-never been used and I hadda go and put it on the roof of 'Ol One-Ton...
-
SYou can swap all the guts to a 47 but there are some slight differences(gussets) in the 47 case that the 42 doesnt have
-
S2 gallons? WHY? It only calls for 6.8 PINTS or 3.4 Quarts. All you will do with 2 gallons is airerate the fluid and starve the bearings...
-
Well here it is. I'm going to discribe my fuel set up and as time and life progresses I'll share more, if y'all have any comments or... -
MMattbo replied to the thread Rear main seal replacement.Keep in mind these are both in the 1993 F-250 7.3 NA subsection, but if you look at the outer diameter measurements sleeve 99387 is...
-
-
MI was under the impression all IDI`s (6.9/7.3) were all the same. (as far as the Crank) maybe the 94, last year some changes were made...
-
MMattbo replied to the thread Rear main seal replacement.Ya I looked again at my order and it was for an F-350 same year same motor. After double checking outer diameter sizes it was definitely...
-
Fwiw, the width of the axle and tire sturdiness/capacity plays a part on stability. I went to #3860 tires first, then to a 5" wider... -
Duals look really cool....... And you COMMAND the parking lots. My truck started life as a single wheel one ton and at some point in...
-
u2slow replied to the thread DRW to SRW Pros cons discussion.Fwiw, the width of the axle and tire sturdiness/capacity plays a part on stability. I went to #3860 tires first, then to a 5" wider... -
I thought you put that to bed. Given what I see right now, I'm in Nero's camp. I found a wiring diagram for a 1G alternator. This... -
OOld Goat replied to the thread So what did you do with your truck today?.Finally got the bed back on and bolted down. Fuel lines reconnected. I pulled it because front tank was leaking, really didn`t see from...
-
GI thought you put that to bed. Given what I see right now, I'm in Nero's camp. I found a wiring diagram for a 1G alternator. This...
