Latest activity
-
Pesky worm gear clamp on the lower radiator hose at the radiator kept working loose. I happened to be at Harbor Freight and saw these... -
OOld Goat replied to the thread Rear main seal replacement.Hacked89 did have a good YT Video of installing the Real Main. Guess he took it down. I watched it several times before I installed the...
-
OThis is why I like to use a thin coat of RTV on both sides of most gaskets. It makes clean up SOOO easy the next time. The old gasket...
-
been wanting a e locker for several years now, And finally got around to it! made a short video about it as well -
-
david85 replied to the thread e locker 10.25.Nice job! As I mentioned on the other thread, the factory bulkhead connector is probably not worth the trouble. Using a heat shrink on...
-
Nero replied to the thread Linking gas tanks.Lots of semi trucks do this already. Just tap at the lowest point on both tanks and they'll level each other out. Only downside is you... -
love it, just did the same on mine, and basically have seen all the things you have. the starboard was a nice touch!
-
david85 replied to the thread Factory Ford E-Locker Install.If I were to do it again, I’d probably just pass the wires through the gap for the gasket, with a couple of notches carved into the...
-
-
So I had an idea and I didn't know if it would work or if anyone else had tried it. So on my truck my Fuel selector valve doesn't work... -
MI understood well enough. Those gaskets seem like they're welded to the engine and other parts. I've seen it enough times to know what...
-
You just replace the injectors and the hpop as a pair, not much different than our idi's. My old mans rv is a 2001 PS and its chugging... -
KansasIDI reacted to IDIBRONCO's post in the thread Powerstroke 2 IDI no Turbo conversion with
Like.
The lifters and the piston cooling jets (I think) are the same. I agree here. They are. I had an intercooler line blow off of a '99... -
1G type of alternator? If so, check the two wire plastic connector to see if it has come out/loose. It has a plastic spring on the...
-
Thank you, I agree. Out of every hotshot rig I've seen, I think mine looks the best proportion wise. The flatbed helps the look too I...
