Latest activity
-
BeastMaster replied to the thread Is it my alternator?.I'd still be a little careful regarding the wiring around an alternator and potential electric shock. Alternators are highly inductive... -
catbird7 replied to the thread Installing engine and trans together..I've pulled two and installed one. Every occasion engine and trans were still bolted together, core support removed. One key piece of... -
It'd be nice if there was a simple controller that would screw in the coolant port like the 6.9 unit did, and then vary on-time based... -
it wont be cheap but could you import some parts from the US? I am sure there are several members on here that have the spare parts you...
-
ROCK HARVEY replied to the thread Oil Pressure Gauge reading way low.I have the auto gage by autometer set in my truck. The oil pressure gauge sticks at zero when I start the truck until I tap the gauge to... -
catbird7 replied to the thread DRW to SRW Pros cons discussion.If it was originally a single rear (typical pick-up), the "dually conversion" must be simply a set of wheel spacers allowing the duals...
-
Aasmith replied to the thread Powerstroke 2 IDI no Turbo conversion.it wont be cheap but could you import some parts from the US? I am sure there are several members on here that have the spare parts you...
-
WrenchWhore replied to the thread Powerstroke 2 IDI no Turbo conversion.When people are blowing up IDI's for fun I usually tell myself it has cavitation real bad and the block is cracked. Makes life a whole... -
If you have ton of power strokes available, and you like the cab and chassis, power stroke swap it. Sure it takes a little electrical...
-
I don't want to share how much I already payed for the F.O.R.D. since it is in my ownership. :cry: In the US you would probably say that...
-
Be happy it wasnt one of the high $$$ ones. I might shed a tear if one of my team ran over their optrel. Thatd be 800$ down the tubes... -
BBooyah45828 replied to the thread Self regulating glow plugs.It'd be nice if there was a simple controller that would screw in the coolant port like the 6.9 unit did, and then vary on-time based...
-
Be happy it wasnt one of the high $$$ ones. I might shed a tear if one of my team ran over their optrel. Thatd be 800$ down the tubes... -
ISPKI replied to the thread Cup holders.Be happy it wasnt one of the high $$$ ones. I might shed a tear if one of my team ran over their optrel. Thatd be 800$ down the tubes... -
I always gotta learn the hard way...this helmet was brand new-never been used and I hadda go and put it on the roof of 'Ol One-Ton...
