The_Josh_Bear
Latest activity Postings About
-
-
Still plugging along getting stuff put back together. Got the serpentine setup from @Nero installed minus the power steering pump and... -
Thanks Gents.
-
Plus, if your cables aren't allowing full current to flow to the starter it will likely burn out prematurely. It was expensive but I'm...
-
The_Josh_Bear reacted to nelstomlinson's post in the thread My '89 is dead, what's happened? with
Wow.
Those cables I thought were good weren't so good. I cut into the wire leading from the battery+ to the starter relay, and it was pretty... -
If you have no voltage at fuse 18 that makes me think you have a burned up fusible link. They are all there at the start relay on the...
-
The_Josh_Bear replied to the thread So what did you do with your truck today?.I've towed enclosed trailers for about 17 years now and I've always wondered what those double tube receivers were for... finally you've...
-
The_Josh_Bear reacted to Nero's post in the thread So what did you do with your truck today? with Like.
No I purchased the flange and down pipe from CDD, they were the only ones who could have it out fast enough for my timeframe I'm working...
-
The_Josh_Bear reacted to hacked89's post in the thread So what did you do with your truck today? with Haha.
I appreciate your openness to post that weld. Did you also tig that first picture?
-
The_Josh_Bear reacted to IDIBRONCO's post in the thread So what did you do with your truck today? with Like.
Well I sure read your first post wrong. I thought that the blow by stops when the engine gets warm and then starts again when it cools...
-
The_Josh_Bear reacted to FrozenMerc's post in the thread So what did you do with your truck today? with Like.
I fixed my dented tailgate over the weekend, also fixed the rust bubbles on it while I was in body work mode. Took the furball to...
-
Cam re-adjusted. Back together we go.
-
I started the car for the first time. I didn’t install the cam in this and could tell something was off timing wise. It wouldn’t even...
-
The_Josh_Bear reacted to IDIBRONCO's post in the thread To penetrate or not to penetrate. with Haha.
That sounds an awful lot like "you can't" to me.
-
The_Josh_Bear reacted to FrozenMerc's post in the thread To penetrate or not to penetrate. with Wow.
You can with the right borescope. We have these ViewTech VJ-4 scopes at work that we use to scope IDI style engines all the time. They...
-
The_Josh_Bear reacted to Ohiogoldfever's post in the thread To penetrate or not to penetrate. with Haha.
I like your attitude. Some of these fellas are a bit tightly wound. I say juice er up and bar it over. If it’s stuck it’s stuck...
-
-
Loading…
-
Loading…
