Search results
-
B
Low Vacuum Pressure Switch
Can anyone tell me how this switch works? It's the tuna can located on passenger wheel well that has a vacuum line plugged into it and a three wire electrical connector. My issue is that the brake warning light on my dash is always dimmly lit. It's not because of the parking brake itself as I've...- Bo-Jangles
- Thread
- Replies: 19
- Forum: 6.9L IH & 7.3L IDI Diesels
-
B
Possible Injection Pump Issue?
1989 F-250 / 5Spd w 148k miles. When the rpms are 2k or above and I let completely off the accelerator pedal it is hard (stiff) when trying to get back on the throttle. There seems to be excessive resistance at the point of initial throttle input. This issue goes away when the rpms drop below...- Bo-Jangles
- Thread
- Replies: 14
- Forum: 6.9L IH & 7.3L IDI Diesels
-
B
Electric Fuel Pump Setup - Is this no good?
There is a small electric fuel pump mounted on the passenger frame rail plumbed into the fuel line between the tanks and the mechanical lift pump. It is always on when the truck is running (power coming from fuel shut off solenoid) How bad of a setup is this? Just read on another forum that the...- Bo-Jangles
- Thread
- Replies: 16
- Forum: 6.9L IH & 7.3L IDI Diesels
-
B
HELP! Can't Remove CDR Valve
1989 F250 7.3 For the life of me I cannot remove my CDR valve. Removed both mount bolts and clearing intake but no matter how much I wiggle, rock and no matter how hard I pull the unit will not come out. Can see a clamp (that looks permanent) that holds valve to the tube but nothing down where...- Bo-Jangles
- Thread
- Replies: 4
- Forum: 6.9L IH & 7.3L IDI Diesels
Latest posts
-
-
-
-
-
Transmission bench rebuild kit is it decent? E4od rebuild
- Latest: 94turbocrewcab-lb